50pfp5332d
got this tv not working.
found
Hello
The power regulator PCB has some fault it it. It does not outs proper regulated voltages needed to the other PCBs in your TV. Normally Plasma TV power regulator PCBs are very difficult to repair, and PCB as whole should be replaced. If you give this set to Philips Authorised service center, they also will do this, and they too can do only this. In my opinion, it is best to get it repaired by Philips Service center, because, Plasma displays are very sensitive to static voltages, and repairing it without proper measuring instruments and circumstances, may damge it and it is irreparable. If fuse is gone out, you must aware that there must be som sort of short, or overload inside your TV circuits. If you have technical skill, a proper knoledge of the power regualtor working, and mor confidence and patience, you can do this. You have the ability to follow the schematic diagram of your set, which can be obtained from philips website. You must have a high quality digital multimeter, and static free DC soldering iron to go on. Some times, an Oscilloscope may also be needed.
Beware, your TV has built on most modern electronic technology, and is colstly one. Never attempt anymore on it, if you are fully aware of its working principles, and proper knoledge in Electronics. Philips uses some special components of their own, which cannot be purchased locally.
Determine yourself, what to do. OK.
2/2/2011 1:26:40 PM •
Philips...
•
Answered
on Feb 02, 2011