20 Most Recent Kyocera FS-2000D Laser Printer - Page 6 Questions & Answers

this means you need to install the maintenance kit. Your basic manual will have a full description and instructions for the maintenance process. If you don't have the manual you can find it at http://usa.kyoceramita.com/americas/jsp/Kyocera/downloadsupport.jsp

Turn the printer off.
Disconnect the AC power-cord.
Take a bottle of denatured alcohol, and some "Q-Tip" (trademark) sticks.
Pour some of the alcohol into a small disposable container.
Dip the end of the stick into the fluid, and gently wipe the dirty rollers.

Or, take it to a professional printer-repair technician.

u need to push the drum in properly,open the lhs door ull see waste toner above it the drum u neet to push it in until it clicks

very stange 1st thing u need to try is upgrade firmware and perhabs take the tray off completley and re fit it again Make sure the connector on the tray and the copier not damaged in any way

Telephone your local Kyocera business office, and ask them to dispatch a service-technician to your location, so that the problem can be diagnosed and fixed.

Has it always been slow, or is that a recent development? At its fastest, the FS-2000 only prints 31 pages per minute, and that's for regular single-sided 8.5" x 11" with no special requirements. Anything else will (thick paper, longer paper, duplexing, etc.) will slow the print speed down.

One thing you can try to speed up the print speed is to change your spool options in the print driver. Go into the print driver (Control Panel > Printers & Faxes, right click on the FS-2000 and select Properties) and find where the spool options are located. Try selecting different spool options (such as waiting to send the job until all the pages have spooled, or sending it page by page) to see if any of them affect printing speed.

There are other options in the print driver's properties which could affect printing speed as well. Look around the different tabs and try changing some of the options to see if they make any difference.

You can also go to Kyocera.com and download and install the newest version of the print driver, which might speed up processing as well.

Hope that helps!

0150 is a problem with either the engine board or the EEPROM chip that sits on the engine board. If you want to do it yourself, you can open the printer up and reset the chip on the board as well as reset all of the connectors that plug into the board. Otherwise, your best bet is to call a Kyocera service technician.

7410 is generally a drum installation error. Did you recently remove or replace the drum unit? If so it is probably just not sitting correctly -- take it out and put it carefully back in again.

Otherwise the problem could be a bad signal coming from one of the circuit boards, or it could be a bad drum unit. You could try replacing the drum unit, but that may or may not fix the problem.

toner motor lock error -take the toner out and hit it a few times all the way round and shake hard.possibly a new toner or u dont use the printer that much so it sets.other options r expensive

7410 refers to drum not being inserted properly on the left hand side where the waste toner bottle is ull see the drum just above it push it it properly.