20 Most Recent
Sony BDP-S300 Blu-Ray Disc Player - Page 8 Questions & Answers
Sony bluray player flashes wait
see this causes and fix it. God bless youIf your mini DVD player reads "No Disc" after you've loaded the disc,
it means the machine isn't reading the DVD. Take the DVD out again and
clean it. It's quite possible that the disc is simply dirty and cleaning
it will solve the problem immediately.
If you try several different discs and clean them and you still
receive a reading saying "No Disc," then the problem is in the laser and
this will need to be fixed by a professional.
Clean a DVD disc:
- Hold the disc by its central hub and outside edge.
- Blow dust from the bottom surface with a can of compressed air.
- Clean dirt and fingerprints from the bottom surface with a
lint-free cloth dampened with CD/DVD-cleaning fluid or denatured
alcohol, wiping from the center outward.
- Clean the objective lens:
- Remove the housing and lift the hold-down clamp to expose the lens.
- Remove dust with canned air or soft brush. If needed, use a foam swab or a camera-lens tissue dampened with lens fluid
I put a disk in
The disc tray does not eject when the OPEN/CLOSE button is pressed.
Solution
Follow the steps below to troubleshoot this issue.
IMPORTANT: The
disc tray will not open while a disc is loading; this is normal
operation. If this is the case, wait until the disc is finished loading
before pressing the OPEN/CLOSE button to open the disc tray.
- Make sure the disc tray is not locked; if necessary,
- Perform a power reset.
- Press and hold the POWER button for 10 seconds until the BD player turns off.
- After the BD player turns off, press the POWER button again to turn it back on.
- Attempt to open the disc tray by pressing the OPEN/CLOSE button on the front of the BD player.
- If the disc tray still does not open and a disc is stuck inside, follow the steps below to force the disc tray to eject:
- Turn off the BD player.
- Turn the BD player back on.
- Immediately after POWER ON is displayed, press the STOP button on the front of the player. IMPORTANT: Only use the STOP button on the front of the BD player. The remote control cannot be used for this operation.
NOTES:
- The disc tray should eject and the BD player will turn off. If it does not eject, repeat steps A-C.
- It may be necessary to press the STOP button in step C two or three times.
If the issue is still unresolved, service may be required
Not finding what you are looking for?