20 Most Recent
Maytag Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer - Page 3 Questions & Answers
Locking mechanism won't lock
Either out of adjustment, bad lid latch, or bad main control very seldom is the control bad maybe 1out of 100 easy way to check adjustment with unit off just open and close lid if it closes all the way down with no bind or resistance adjustment is fine start with a new lid latch not that expensive andthis is a common fail part
1/29/2014 1:30:22 AM •
Maytag...
•
Answered
on Jan 29, 2014
Maytag centennial washer - not draining on some settings
Check outlet hose for kinks or restrictions. Make sure the outlet hose is free to expel water at full volume. Make sure the outlet hose is not mounted to high. Check pump impellor has all it's vanes intact. Check for coins in all hoses & pump.
12/22/2013 4:12:57 PM •
Maytag...
•
Answered
on Dec 22, 2013
The drain hose on my maytag centennial was leaking
You may have interrupted the drain cycle so you may need to empty all the water out to reset sensor.maybe move machine to w/h door and lower the drain hose outside until most of water is removed then start wash again from scratch. Or your out of balance switch activated if you tilted the machine, if so reach in the back at top of bowl and you should find a lever arm, jiggle gently back and forth then try the machine again.
10/25/2013 7:43:36 PM •
Maytag...
•
Answered
on Oct 25, 2013
Not finding what you are looking for?