20 Most Recent
Maytag Centennial 3.2 cu. ft. SuperSize Plus Top Load Washer - Page 4 Questions & Answers
My washer doesnt spin or drain. any solutions/
The machine must drain to spin. So assume it is a drain problem for now. There could be a sock in the hose between the tub and drain pump. Or even jambed against the pump. You'll have to get inside to see. It's also possible the belt has slipped from the pump. But i believe yours is a direct drive set up, so there are no belts.
1/21/2013 3:04:38 AM •
Maytag...
•
Answered
on Jan 21, 2013
Agitator running from first of cycle and water running in at end of spin
i have the same problem the hot & cold water is also a load senser switch part # w10248240 the load sensor is built into this switchfind a video on youtube how to open your top panel to the control knob switches you will see the switch #w10248240 there will be a hose to it make sure you can blow thru the hose if clear close the lid unplug the two plugs going to the switch pull the on button to start the cycle if nothing happens its the load switch if it agitates its the timer mine was the load switch one appliance man told me he had both parts go bad at the same time but like i said mine was the load switch took me all day of online serching to get the problem fixed but i found the answers on this site part i found at amazon 50.00 dollers its finaly fixed
1/21/2013 2:04:16 AM •
Maytag...
•
Answered
on Jan 21, 2013
Motor just hums and will not spin
Possible that the starting capacitor to the motor is weak or damaged and does not have the value to initiate the start . You can couple a capacitor in series to confirm before replacing the component.If the motor still hums then it is due to winding failure and the motor must be replaced ONLY if this is worth the cost.
1/15/2013 11:29:52 AM •
Maytag...
•
Answered
on Jan 15, 2013
I get what look like rust streaks on my white
1. Iron or manganese in the water supply. • Avoid using chlorine bleach on rust stains. It will make them darker and more obvious. • When iron is dissolved in the water, use granular detergent plus a non-precipitating water conditioner, such as Calgon or Spring Rain*. Better results may be obtained by dissolving detergent and water conditioner in the wash before adding the clothes. Be certain that all clothes are down into the water before starting washer. • If the iron is suspended in the water (it will settle out), attach a rust filter to the faucet and inlet hoses or to the water line. • If iron or manganese stains are a recurring problem, the customer may need a special filter or chemical feeder installed in the home to remove these minerals from the water supply. To remove: Launder with RoVer* Rust Remover Part No. 057961 using the directions below: • Top loading washers: a. Fill the washer with water (no detergent), selecting a temperature suitable for the fabric (hot or warm). b. Add 1/3 cup RoVer and let it dissolve by agitation. c. Add clothes and allow washer to complete the cycle. d. Follow up with an additional wash with detergent.
Be sure to check the spin basket for rust spots also.
1/11/2013 11:35:45 PM •
Maytag...
•
Answered
on Jan 11, 2013
Not finding what you are looking for?