20 Most Recent LG 37LC7D 37 in. LCD HDTV - Page 5 Questions & Answers


Here's a link to the service manual for a slightly larger LG LCD TV. Perhaps it may be of some help? The troubleshooting section appears to be the same for many models of LG TVs...

http://www.observations.biz/MANUALS/LG_LCDTV/42LF66.pdf

LG 37LC7D 37 in.... | Answered on Nov 29, 2011


Hello
Do check the infrared emission from your LG remote control. Just to to this link, where you can see details about it. If infrared emission is there, and still TV does not accept it, the infrared sensor inside your TV is faulty and should be repaced. Ok
http://www.fixya.com/support/r8733688-common_faults_in_infrared_type_remote

LG 37LC7D 37 in.... | Answered on Nov 20, 2011


Check the power supply DC filter caps first, also check the DC output voltages.
Service manuals:
http://elektrotanya.com/?q=showresult&megnev=LG&megnev2=37LC7D&kategoria=tv&kat2=schematics

If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on:

Basic LCD monitor and TV troubleshooting guide:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide
http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting
http://www.fixya.com/support/r7406380-tv_training_manuals
Failed TV and Monitors: http://s807.photobucket.com/albums/yy352/budm
Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague
Parts: www.shopjimmy.com
Capacitors kit: http://lcdalternatives.auctivacommerce.com/Default.aspx he can make you a set of caps.
Or www.digikey.com, just make sure to use caps with low ESR, 105c, high ripple current and long life rating such as PANASONIC FM or FC series.
Please post back what you find.
Please leave rating if it helps.

LG 37LC7D 37 in.... | Answered on Nov 09, 2011


See step 2:
LG:
1) Test the remote:
The remote control puts out IR (InfraRed) signal that human eyes cannot see, to find out if the remote is sending out the signal or not you just point the remote at the digital camera's Lens (Digital Camera can detect IR), you should see flashing light on the camera's screen when any one of the remote button is pushed. If you do see the flashing on the camera, then the problem is in the TV IR receiver or the main logic board; more troubleshooting with scope will be needed to look at the signals.
Parts: www.shopjimmy.com

2) If the remote checked out OK, then look at the back of the TV for the "REMOTE INPUT", use a mini-phone plug and insert the plug into the remote input jack in and out a couple times to clean the switch contacts that select between the front IR receiver of the TV or the rear panel IR input jacks.


See: http://www.fixya.com/support/t9056223-remote_doesn_39_t_work_all

LG 37LC7D 37 in.... | Answered on Oct 07, 2011


In most cases the standby light might blink with different rapidity to indicate a fault relevant to the processor. It is possible that most of these indicate that there are errors in the processing section . Since there is a possible short or leak in the circuit the output driver section can take in huge current to trip the SMPS or from advice from the micro processor. Remove the power plugs and make sure that high voltage sections are discharged of the potential stored in capacitors. Look for visible signs of leak or of busted capacitors. Look for bulged capacitors or damaged components- burnt or busted. Use a multimeter to check the continuity or shorting in components, if so detach from circuit and test . If the voltage builds up and the set power ON and then shuts up then the suspected section must be checked in detail.

http://focus.ti.com/docs/solution/folders/print/387.html

The processor must have the +5 voltage to the function properly , the +B and secondary voltages also must be checked to infer the fault. Trace with caution and in running through the signal path , circuit trail.

Check for tips to check the SMPS unit:

http://www.fixya.com/support/r5826301-working_switch_mode_power_supplies

Thank you for using fixya.

LG 37LC7D 37 in.... | Answered on Sep 16, 2011


Hello
You can surlely connect this TV to your VCR, if the VCR has AV output with it at its rear side. Most VCRs will have this video out from it. Just connect this video out connection to your LGs audio video connection by using an audio video cable. This cable will be of three conductor type and can be bought from most of the electronic sparepart shops at your town. Choose a best quality one, when you buy it. After connectiing this cable with corresponding video IN sockets at the TV, switch ON both the devices and select AV2 or AV1 with the help of remote AV source button. The AV cable will have three conductors, a flat type cable haveing red, white and yellow colured RCA pint at both end. Coincide these colours to both TV and VCR when connecting it. That is all, and you can play your favourite video tapes by VCR.


gopakumarg43_25.jpgThe AV cable will look like this. OK

LG 37LC7D 37 in.... | Answered on Aug 27, 2011


The tv have a power supply board problems.That the board where the power a/c cord plug into it.Take the tv aparts and check the tv power supply board carefully for dying and leaking capacitors components parts to causes this delay picture to come on are alway bulges ups on to it tops or puffing onto it tops.U have all the tools and understanding basic electronic also can do basic soldering work too?Yes?All these dying and leaking capacitors parts are bulging up or puffing ups onto it tops all these capacitors parts are dying must be replace will solved and fixed the delay on problems.Or tries websites Shopjimmy.com,Ebay.com buy a whole new tv refurbish power supply board for the replacement.

LG 37LC7D 37 in.... | Answered on Aug 25, 2011


Ur tuner board is dead.Replaced this board to get picture back.Tries Shopjimmy.com,Ebay.com for the board part.

LG 37LC7D 37 in.... | Answered on Aug 21, 2011


When it shuts off does the power light stay on like the unit is still on?If yes,try shining a bright flashlight at the screen and see if you can see any video.If you can your power and main boards are ok.you would then probably need an inverter board or panel.If it is shutting completely off you need a main total assembly since you have already replaced the power supply.The main total assembly is avery common issue on lg lcd tv's.

LG 37LC7D 37 in.... | Answered on Aug 21, 2011


the problem is the power supply board. we are an lg servicer. your welcome

LG 37LC7D 37 in.... | Answered on Aug 21, 2011


The main board needs to be replaced.

LG 37LC7D 37 in.... | Answered on Aug 21, 2011


The problem you have mentioned is a clear case of logic control circuitry malfunction. These circuits are part of the main A/V board and replacing it should resolve the problem. The board costs about 100$ and is not that hard to replace so let me know if you wish to do it yourself.

LG 37LC7D 37 in.... | Answered on Aug 17, 2011


Check coils L4010, 4011, 4012 located below the hdmi and just to the left of p400

Credit: http://www.repairworld.com/

LG 37LC7D 37 in.... | Answered on Aug 16, 2011


There should be a menu option for "aspect ratio" somewhere. The old standard was 4:3. The new is what was colled "wide screen" and is 16:9. I believe that this is under the video setup menu.

Dan

LG 37LC7D 37 in.... | Answered on Aug 15, 2011


Hi,

I am sorry to hear regarding the trouble.

This is a common problem on this models.This is classic bad electrolytic capacitor trouble on the power board they leak or balloon up when they start to fail and from a cold start can be particularly troublesome.Unfortunately, this would not be a ' quick fix '. You need to dissemble the TV to repair the same.

There are 2 options :

1. Replace the bad caps on the power board. The caps would cost around $20 from radioshack or fry's.

2. Replace power supply board which would be expensive.

If you have electronics repair experience, revert and i would be able to provide the steps to repair it. If the TV is less than 5 years old, it would worth repair.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

LG 37LC7D 37 in.... | Answered on Aug 07, 2011


First place to check will be the power supply module, need to verify if it is putting out staedy DC first. This can be due to simple thing such as bad caps.
Please read my guide for more details.
Service manual: www.elektrotanya.com

If you are going to DIY and have proper tools, electronics knowledge, and know safety precaution then please read on:

Basic LCD monitor and TV troubleshooting guide:
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide
http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting
http://www.fixya.com/support/r7406380-tv_training_manuals
Failed TV and Monitors pictures: http://s807.photobucket.com/albums/yy352/budm
Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague
Parts: www.shopjimmy.com
Parts: http://interliquidparts.com/

Capacitors kit: http://lcdalternatives.auctivacommerce.com/Default.aspx he can make you a set of caps.
Or www.digikey.com, just make sure to use caps with low ESR, 105c, high ripple current and long life rating such as PANASONIC FM or FC series.
Please post back what you find.

LG 37LC7D 37 in.... | Answered on Aug 01, 2011

Not finding what you are looking for?
LG 37LC7D 37 in. LCD HDTV Logo

324 questions posted

Ask a Question

Usually answered in minutes!

Top LG Televison & Video Experts

Ekse

Level 3 Expert

13434 Answers

The Knight
The Knight

Level 3 Expert

76177 Answers

RONALD CARTER JR

Level 3 Expert

438 Answers

Are you a LG Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

LG Televison & Video

  • LG Televison & Video

Most Popular Question

months tv loud cracking noise when first

  • Televison & Video
Loading...