20 Most Recent
Frigidaire FRS23KF7AB Side by Side Refrigerator - Page 10 Questions & Answers
Frigidaire Model FGUS2642LF1 leaking under the freezer. The appliance tech replaced the freezer door then stated the fridge needed to be defrosted for 24 hrs. My question is why?
All guess work but...
Scenario 1
Your problem was that it need a defrost timer or defrost heater. They are inexpensive parts. He sold you a door as a bonus (for him). Doors only need a new gasket if they don't seal properly. The evaporator at the rear of the freezer is a big lump of ice, and instead of using a heat gun for defrost it, he left you to do it.
Scenario 2
It only need the defrost drain cleaning of gunk and sold you a door as a bonus!
I had Scenario 1, but the local tech was honest. He said I have a defrost timer on the van. He fitted it and said "I can leave you to defrost the ice with a hair dryer and put the back panel back and shelf supports on the freezer, or I can defrost with a heat gun, but it will add 20 minutes to your bill. I go him to finish the job, the cost was minimal.
My Frigidaire Gallery refrigerator showing HI temp.and with code5Y and EF, what does it mean?
An EF code is indicative of an Evaporator Fan Circuit Failure. Can it be stopped by ice or frost? Absolutely. Press the freezer up button and the freezer down button simultaneously for 6-8 seconds and you will enter a test mode. Every time you press the fresh food button after entering the test you will advance to the next test. They are not in numerical order. Go to test 26 (The defrost circuit test) and it will show CL for closed or OP for open. If it shows OP you have a defrost issue. If CL there is no defrost problem. Next go to test 15 - keeping in mind they ( the tests are Not in numerical order). When you get to 15 press the main power on/off button. The 1st time you press it the display will show LO and the fan should be on low speed. The next time you press the power button it will show HI, and the fan should be on high. It is a twelve vdc fan motor wire colors red, yellow, brown, and blue. They originate at the j6a and j4a connectors. If the fan does not come on in the test the check will be made at the control. There should always be 12vdc between brown and red, and there should be 9 - 12 vdc between brown and yellow in the test. The blue wire is a tach wire and feeds info back to the lower control which is located behind the kick plate underneath the unit. EX factory service 22 years currently an instructor. If you are not equipped with the proper tools and or knowledge please call a competent technician. KEEP IT SIMPLE
How do you get door ajar alarm to stop beeping on upright frigidaire freezer when door is closed
Even though my door was closing fine it was beeping and saying "door ajar", so I first removed the switch. But that wasn't faulty and even with it out of the equation the beeping was there. I fiddled around some more but rather than rip everything apart, I popped out the electronics on the front and twisted off the little round black beeper in the circuit board.
Now I don't have a working door alarm. But otherwise: problem solved! ;)
Frigidaire control lock stuck
Door is open but lock on the control panel won't do anything even if I close the door of my washer how to fix this can't wash clothes because the lock is displaying I tried everything
Ice dispenser only works intermittently...any ideas?
The icemaker might need to be lowered for the freezer then and the check the fill tube . If the fill tube looks frozen the water valve will need to be replaced. If it looks fine then the icemaker will need to be cycled to help determine what could be causing the issue with the ice dispencer.
Not finding what you are looking for?