20 Most Recent Nokia e65 Cellular Phone - Page 6 Questions & Answers

take the battery out. and plug it to the charger with no battery and turn it on if the keybad lights still dont work they likely got fried. if it got wet put the phone without the batter in non cooked rice for some hours it will absorb all the moisture. if its under warrenty take it to your service provider

use the picture i post

Hello, go to menu locate installer, in the installer press option botton then select accepte all. Then try installing or loading again. But make sure the certificate is in date not out of date.

Navigate tot App. Mngr. > Options > Certificate Installation> Select ALL.
If it shows Certificate Expired, just change your system date back a year of two. That should make it work.

Cheers.

plz change ur date and year and then install the themes

you can lock your SMS using an application
here is the link
http://www.getjar.com/mobile/51268/app-lock/
i hope it helps!

Hi this is a very common problem with all flip and slide cameras,phones and even laptops and notebooks, the problem is to do with the data ribbon that connects the screen to the circuit board in the bottom of the phone.
now inside this ribbon are several single strand copper wires and over time open and closing the phone causes these to break and you then lose the connection with the screen.

as this is such a common fault it makes the part itself cheap to buy and cheap to get fitted. it isnt something you can do your self as you need specialist tools to take the phone apart and to fit the data ribbon.

if you want it repaired the cheapest place would be one of those small independent phone shops as the bigger one will have to send it off and you will be charged extra for this, the smaller phone shop should be able to fix it whilst you wait or the next day at the latest.

its up to you if you think the phone is worth getting fixed then it wont cost much to get done.

let me know if you need further assistance ok

plz rate this solution as i have a whole page of unrated posts, thanks..........

i have Phone Nokia E65 uith flasing screen and split in haf two diferent imagine an clear .
The problem was start after i recive fhone call .

use 12345 to activate

Very Easy

Press Menue Button
Goto Settings--General--Personalisation--Themes
Select your theme and Press Apply.

Hello and Welcome to FixYa!
PIN and PUK codes are all service provider (Your SIM / Your Connection) dependent, you can never get it from anywhere else, never get fooled and pay for there to anyone.
All you have to do is to call your service providers via some other phone or landline and talk to a CSR, ask him for the code. He will first authenticate your ownership and will give you your code in ruturn, for free, Its your right to know your PIN/PUK.
I hope you have a clear picture now.
Concerned, Nooh.

If For puk & pin cod problem So Please

There is some problem in your message setting number, please verify with your operator if its correct. As messages are being saved in outbox; that means that message are not being sent. Please do ask if you have any other query. Have a nice day!

Querido amigo, usted TENDRá QUE CAMBIAR EL FLEX teclado del teléfono.

setting > phone setting > automatic keyguard

Hello,
12345 is the factory master code for nokia. If fails, get the code at www.nfader.su
If still fail , get it unlocked at www.unlock-zone.com Regards, Jay__GINT

where can i get an unlock code for nokia 6760 for FREE. all other phones have it for free, why not this one

mic

Hi I have just changed my covers, it is in three parts front, middle and battery cover, first have a good look at your new parts to see where they clip, remove battery and sim, remove the front cover by unclipping it, remove the 4 screws on the back, on the front down the side of the lcd push and slide out the guide rails, watch the small rubber washers at the top and the plastic spacers at the bottom do not get lost, the front can gently be removed watch out for the spring catch that connects the front to the main frame and unclip from the post on the front, open the front just enough to gain access to the one remaining screw holding the middle section, unclip the circuit board at the bottom from the middle frame, prise out the connector bar along the side, watching nothing is catching your frame should come apart, I kept hold of everything in one hand while gently removing the mid section frame that way I did not have to disconnect any of the connectors, clip out the buttons from the side of the old mid section and replace in the new one, then work backwards to reassemble, I had never stripped a phone before but mine is now perfect with its new covers, just take your time and reason it out

cheers
andy