20 Most Recent Frigidaire 24 in. GLD3450RD Built-in Dishwasher - Page 3 Questions & Answers

Take the pump apart, look for a broken rubber flap

Sounds like you have a stuck relay (or shorted triac) on the main control board, which means you will have to replace the control board.

the problem you have is probably in the heat circuit. its trying to heat the water up and keeps running because the water does not get any hotter. you need to check the heater wires and a couple of sensors as well as the heater itself. If you need further help, I’m available over the phone at https://www.6ya.com/expert/dude_653d05454b389bba

Check the bottom or bottom panel of the dishwasher for the schematic it is usually in a plastic sleeve.

This is a control panel issue, it is all one piece.

Does this mean the dishwasher doesn’t work at all or just the display lights? Remember the switch on the wall turns the dishwasher on and off. That could be the only problem !!

CL is a generic clear code. Reset the unit at the household circuit breaker for about 10-15 minutes, and then retry. If the same code comes up then you have a communication error with your main control board, and will require a repair.

It is possible that you have a weak circuit breaker. Use an extension cord and run it from a different outlet on a different breaker.

Hello Paul Maksymowicz & welcome to FIXYA, Your ERROR code SEEMS to indicate you have indeed filled your SAFETY tray (designed to prevent FLOODING). FRIGIDAIRE's solution is to UNINSTALL your unit and (TIP) drain your dishwasher to eliminate your "i30" ALARM condition... Without intervention the SEWAGE situation (I suspect) will reoccur... FIX IT...!! To ELIMINATE the DISPOSER flooding condition (building codes usually require an elevated SYPHON BREAK (adequate))... to prevent back-washing of WASTE-WATER into your cleaning unit (serious health & safety issue). FOLLOW proper installation procedures... (read the manual) and avoid poisoning yourself, your family, associates, visitors, friends & loved ones... (my opinion). https://en.wikipedia.org/wiki/Carnac_the_Magnificent

If you can get it to drain you might try putting a couple of pan of water into machine to clean it out reset by holding down speed button and soil level button together until it gives a sound

Check drain line for obstructions. If clear, drain pump is most likely defective

I believe this is what u looking for part #5304506517 u can buy this almost anywhere try searspartsdirect

On our machine the door latch seems temperamental and we have to push the door closed quite hard. It will then start.

A lot of cause .... first, looks if the drain pump is working well and if it is not stuck or faulty

It sounds like your first problem with the detergent may be that you are blocking the little door that releases the deterget with tall dishes. When you stack the machine hold the door partially open to make sure that you are going to stop the little door opening. I do this on a regular basis when my brain is not functioning. It is hard to address your other questions without being there. For example, make sure that you don't put thin things like chopsticks in the silverware tray so that they go through the bottom and block the lower spray arm. You can open the door during the cycle to see what is going on inside. Lastly, the drain pump will change pitch when the machine is empty of water. Could the noise be that? Also the drying fan kicks in at this point.