20 Most Recent Toshiba REGZA 42 in. Flat-Panel LCD HDTV - Page 6 Questions & Answers


Unless wifi is built in you have to use the Toshiba dongle. The reason is the TV is set up for the Toshiba drivers to run their dongle and no other type..

Toshiba REGZA 42... | Answered on Jul 27, 2011


solution
step 1: At first test your fly back Transformer
step 2 : Test the tube back side bulb and video I.C.

Toshiba REGZA 42... | Answered on Jul 25, 2011


before you run into other issues you need to have this system checked out. most LCD tvs use white or red lights (sometiems other colors) to indicate that the power supply is not working correctly. This is usually the case but could also mean there are other issues instead. Either way i woudl take this unit for service before it no longer works and you cause it more damage.

Toshiba REGZA 42... | Answered on Jun 29, 2011


You have setup your remote for your tv to turn on or off. This might consist of you entering codes into the remote until one turns off your tv.

Toshiba REGZA 42... | Answered on Jun 26, 2011


Any kind of black or colors lines on the tv LCD screen panel,not causes by u it appear by itself only can be repair by replacing the board that call the T-CON board.This T-CON board sit in the middle at the bottom of the tv LCD screen panel.Tries websites like Shopjimmy.com,Ebay.com to buy the refurbish T-CON board for the replacement.

Toshiba REGZA 42... | Answered on Jun 24, 2011


This problems alway power supply board are the problems 90-95% of the times.Take the tv aparts.Tries websites like Shopjimmy.com,Ebay.com to buy a whole refurbish power supply board for the replacement.

Toshiba REGZA 42... | Answered on Jun 19, 2011


Only Toshiba service centre can help you. The cost of replacing the screen so high, it is better to buy a new one. I think someone has broken the scree. If you want to buy a new TV, look for a TV which has a glass front before the screen. These TVs are high end.

sonsunny

Toshiba REGZA 42... | Answered on Jun 17, 2011


Plasma and LCD TV sets are prone to having capacitors in the power supply section fail. This is the most likely cause for the probem you describe. When capacitors fail your will commonly see one or more of the following symptoms.
  • No video, Power light is on or blinking.
  • TV is making a clicking noise.
  • TV takes a while to come on
  • Screen is very dim or flickers.

Again, You can get a power supply repair kit with the parts, detailed instructions, and support from sites such as www.TvRepairKits.com . Or just click here to see more details on their kit.

Here are pictures of capacitors...Notice that the ones below look bloated. They have failed and will need to be repalced.



ecollier2012.jpg
Capacitor being replaced! Fairly easy DIY fix.

ecollier2012_0.jpg
Again, You can get a power supply repair kit with the parts, detailed instructions, and support from sites such as www.TvRepairKits.com . Or just click here to see more details on their kit

Toshiba REGZA 42... | Answered on Jun 10, 2011


Hello
Get into this site where you can download the user manual of your TV for free. If you feel andy difficulty in downloading the same, inform me by FixYa with your email address; and I'll send a copy of it to you by return mail. OK.
www.retrevo.com > Toshiba Manuals > Toshiba TV Manuals

Toshiba REGZA 42... | Answered on Jun 01, 2011


Yes and NO your tv is a LED. To be exact it is a LED Backlight LCD TV. An LED-backlight LCD television is an LCD TV that uses LED backlighting instead of the CCFLs used in traditional LCD televisions. It is not a true LED display but is called "LED TV" by some manufacturers.[1] The use of LED backlighting has a dramatic impact, resulting in a thinner panel, less power consumption and heat dissipation, and a brighter display with better contrast levels. You can go to http://www.regza-asia.com/pdf/LEDTV/XL700/47XL700SPEC.pdf and look at the complete specs for your tv

Toshiba REGZA 42... | Answered on May 28, 2011


your fuse is blown tv replace fuse.

Toshiba REGZA 42... | Answered on May 24, 2011


Hello
First of all reset the TV. for that

press and hold the POWER button
on the TV control panel for 5 or more seconds to reset the TV.
Then connect the TV tt any source like outdoor areiel or cable box etc, select the appropriate input, and retune the TV. First of all, connect it to an external antenna, and set it to autotune.

You must configure the ANT/CABLE input source before

programming channels (-left-hand column).

If the ANT/CABLE input signal type is set to Cable, the

automatic channel programming process erases channels

that were previously programmed into the TV's memory.

If the ANT/CABLE input signal type is set to Antenna, the

automatic channel programming process adds newly found

channels to the existing set of programmed channels (and

does NOT erase channels that were previously

programmed into the TV's memory.) To remove an Antenna

source channel from the memory, you must manually delete

it.

To tune the TV to a channel not programmed in the channel

memory, you must use the Channel Number buttons on the

remote control.

Programming channels when the ANT/CABLE input is

configured for Cable will take substantially longer than when

the antenna input is configured for Antenna. This is normal;

however, once channel programming is finished, you should

not have to repeat the programming process again unless
your Cable TV service lineup changes significantly.
Find out the received channels are clear or not. If they are clear, your TV is perfect, and the input device you connects ot the TV is faulty. OK.

Toshiba REGZA 42... | Answered on May 20, 2011


If your computer has an HDMI or DVI external monitor plug, you can use a cable to plug into an available HDMI plug on the TV and change the input. Your computer image will show on the tv as well. If your tv came with a VGA plug (smaller and would also be named PC) you can plug into this and change the input on the tv. If your computer only has a VGA plug and the tv does not have a VGA, the picture will look stretched.

Toshiba REGZA 42... | Answered on May 13, 2011


looks like its damaged. Unfortunatelly all you can do is send it of to get it fixed or replaced.

Toshiba REGZA 42... | Answered on May 11, 2011


Brand Code: 0156 Direct Code: 536, 581, 063, 271, 098
More codes and directions here

Toshiba REGZA 42... | Answered on May 08, 2011


The first thing to try is to unplug the TV, leave it unplugged for about 60 sec, the plug it back in. If the problem persists, this is most likely an issue that will need to be resolved by an electronic repair store/facility.

Toshiba REGZA 42... | Answered on May 06, 2011

Not finding what you are looking for?
Toshiba REGZA 42 in. Flat-Panel LCD HDTV Logo

338 questions posted

Ask a Question

Usually answered in minutes!

Top Toshiba Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76204 Answers

matt martin
matt martin

Level 3 Expert

1257 Answers

Cindy Wells

Level 3 Expert

6068 Answers

Are you a Toshiba Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

REGZA Toshiba

  • REGZA Toshiba

Most Popular Question

best converter box use toshiba regza

  • Televison & Video
Loading...