Top 20
Frigidaire 20.3 Cu. Ft. Frost-Free Upright Freezer - White Questions & Answers
Freezer Will not freeze in some areas
Check the door gasket near those shelves.
Make sure the condenser fins or tubes have adequate air flow for cooling (it looks a bit like a small but fat car radiator). In most freezers, this will be in the bottom in the back. You may have to remove a vented cover to check this. Usually there is a fan blowing air through the condenser. Carefully vacuum out any dirt in the condenser (the fins are delicate and bend easily), and verify that the fan runs smoothly when the compressor is running.
Put a thermometer in the freezer right by the cold air inlet to verify that the refrigerant is doing its job. It should read 0 degrees F. or below (-18 degrees C). If it doesn't get down that far, the compressor needs to be recharged or replaced.
If the door has been hit hard (somebody falling and slamming into it) the door insulation may be damaged there. Check to see if the outside of the door feels cold there compared to the rest of the door. If it does, the door needs to be repaired or replaced.
Hi. We've got used ("as is") Electrolux Frigidaire
Not sure if u still need help but the first thing I would do is remove the grills on the front and back and vacuum out the fins on the condenser...dust and grime collects here and will cause the unit to overheat and not cool properly....sometimes an air compressor can be used or air in a can for the hard to reach places.
Tr this and see what happens...good luck
Cooling problem
if this control is in the freezer, in the middle, rear wall..its a damper control and its ok
Getting error code 36 hour duration
I appreciate your inquiry, friend!
Based off what you have described your Frigidaire freezer is displaying an error code of 36 hours. Normally it will display that once power has been restored, it is indicating that the freezer has been without power for 36 hours. Hold the "alarm reset" for 3 seconds and that should help clear out the code. I hope this is helpful. -Matt
When I used to shut my door it sounded like a whistle, kinda like an elk bugle. Now it gurgles, like water in a tube.
Hello Tim;
My name is Peter. I am a retired field service refrigeration technician.
You do not have a major problem. This is a easy fix.
When you open your freezer door and then close it you are pushing air into your freezer. This is where the sound is coming from.
On your drain tube in the back that goes to your drain pain there might be a black rubber grommet on the end. The initial design was to put this restrictive rubber element from having air go up your drain tube. Over time the rubber dries and restricts the defrost drain and retains water.
If you have this do what I do on service calls - remove it and throw it away.
You may have a snake type drain tube to your drain pan. Once again the manufacturers engineers, with no field experience, decided to put a loop in the drain tube to prevent warm air getting into your unit. Well, the defrost condensate gets caught in the loop. That is where you are hearing the noise.
The drain tube use to be a straight tube. And so, that is where we are back to. It worked fine. Manufacturers changed it and now us technicians put the straight drain tube back in.
Error code 0F
Good Morning Stephanie Garcia, thank you for your post!
From the information you have provided your Frigidaire freezer is displaying an error code of "OF". Typically, an "OF" stands for power off, you should be able to press the up arrow three times in a row within five seconds to turn your freezer back on. If that does not help correct your issue you may want to perform a reset and you can do that by unplugging the power cord for roughly ten minutes. I hope this helps. -Matt
When turning freezer on it buzzes and chatters what could be the problem?
there should be 120vac at the overload and relay on the compressor. if a 120vac is present unplug the freezer and check for continuity thru the relay and overload. if the overload and rely is ok you may have a grouned compressor or open winding at the compressor. perform a continuity check from the c-s then c-r then s-r then c-gnd then s-gnd-r-gnd. readings should be infinity, if not you have a bad compressor. the work should be performed by a trained appliance technician.
What number should i set the upright freezer control
Thank you for your inquiry, friend!
Normally it is recommended to set your Frigidaire upright freezer to zero degrees. It is your option to make it cooler if you choose too. I hope this information has been helpful. -Matt
How do you turn off your freezer to clan it out and why does it run so long
Thank you for your post, friend!
To turn your freezer off you should be able to disable power from the control panel or you can disconnect power from your freezer to clean it out.
The compressor on your freezer will continue to run until the temperature has dropped to its setting. The thermostat inside of your freezer should tell the compressor to stop running. If you feel your freezer is running too long you may want to check to make sure the rear is cleaned out buildup of dirt or debris can cause your freezer to overwork. I hope this information is helpful to some degree. -Matt
Moved. freezer worked but won't work at new location.
Hi friend, thank you for your post!
I understand that your Frigidaire freezer is currently not working in the new outlet. I would adjust the temperature to a lower setting to see if that would start the compressor to start cooling. Is your appliance getting power to it? If you could provide feedback regarding your appliance I would like to provide see what additional information I can provide you. -Matt
Not finding what you are looking for?
