20 Most Recent Norelco Advantage 6705 X Electric Shaver Questions & Answers

You will find batteries for model 6705X at shaveroutlet.com. See link belowhttp://shaveroutlet.com/shaver-replacement-parts/shaver-battery-pack-for-most-norelco-more-p-278.htmlScroll down item page for viedo tutorials for installation tips

For a helpful video showing how to install the heads, see the link below from shaveroutlet.com then scroll down for videohttp://shaveroutlet.com/shaver-replacement-parts/norelco-philips-hq167-cool-skin-replacement-heads-p-247.html

The yellow buttons on model 6705X are used to dispense the Nivea skin lotion that is a feature of this model. The lotion cartridges are for sensitive skin and are inserted on the back of the shaver.These lotion packets can be found at shaveroutlet.com at the link belowhttp://shaveroutlet.com/shaver-accessories/norelco-hq170-cool-skin-nivea-lotion-5pack-box-p-261.html

Most likely, the battery is dead and needs replaced. You will find the correct battery type at shaveroutlet.com. See link below

http://shaveroutlet.com/shaver-replacement-parts/shaver-battery-pack-for-most-norelco-more-p-278.html

To replace, start by removing the lotion packet cover on the back. Then remove the 4 screws to remove the battery compartment cover and access the batteries. For easier replacement, it is suggested that you use a modified installation technique. This is to break the tabs off of the old batteries rather than unsoldering them from the circuit board. This allows the old batteries to be removed but leaves the tabs attached to the circuit board. You can then solder the tabs from the new batteries to the old existing tabs

You will find at shaveroutlet.com. See link below

http://shaveroutlet.com/shaver-accessories/norelco-hq170-cool-skin-nivea-lotion-5pack-box-p-261.html

Yes, the batteries can be changed. You will find replacement batteries for model 6705X at shaveroutlet.com. See link below

http://shaveroutlet.com/shaver-battery-pack-for-most-norelco-more-p-278.html

To change the batteries, you will need to remove the lotion cartridge cover on the back and then remove the screws on the back of the inner cover. Remove the back to get to the inside of the shaver. The batteries are soldered to the circuit board. You can unsolder them or it is sometimes suggested that you use a modified installation technique. This is to break the tabs off of the old batteries rather than unsoldering them from the circuit board. This allows the old batteries to be removed but leaves the tabs attached to the circuit board. You can then solder the tabs from the new batteries to the old existing tabs. Reassemble in reverse order

If you are not able to do this repair yourself, shaveroutlet.com can do it for you. See link below

http://shaveroutlet.com/professional-battery-replacement-for-most-models-p-374.html

Don't use the NIVEA lotion, just coat your face with a sensitive skin shaving gel, like Edge or Gillette, then run the shaver over your face. The shave is much better and cheaper. I gave up on the NIVEA packets over three years ago.

Just pop up the top with the cutters. Next pull the cutters from the shaver in the back prongs. Insert the trimmer head and reverse operation when you are fiished. [email protected]

Hi,
To open up your shaver, remove the lotion cover and remove all 5 screws with a small flat head screwdriver. They have a star head, but also a flat notch. Since they shaver is water tight, the first time you open it up it will be difficult, but if you pry off with your screwdriver it should pop off.
Towards the head of the shaver the batteries are soldered to the circuit board. Pull the tail end of the batteries out of the plastic holder and cut them at the top end as close to the batteries as you can, or CAREFULLY bend it back and forth to snap the metal. Dispose of the batteries responsibly as you would any batteries.

Hope it helps you.

Go to this link

you can find it.

You should check the switch behind the batteries. You likely dislodged the piece of plastic that presses on the switch. It's simple to place back properly--if that's what the problem is.

the steady red light showing when in charger shows that
it is charging. the blinking red light when taken out of
charger or turned on and off means it is not fully charged.
leave it in charger till red light turns green.

uh...the charger's supposed to have a DC output

Open the screws and replace them

To open up your shaver, remove the lotion cover and remove all 5 screws with a small flat head screwdriver. They have a star head, but also a flat notch. Since they shaver is water tight, the first time you open it up it will be difficult, but if you pry off with your screwdriver it should pop off.
Towards the head of the shaver the batteries are soldered to the circuit board. Pull the tail end of the batteries out of the plastic holder and cut them at the top end as close to the batteries as you can, or CAREFULLY bend it back and forth to snap the metal. Dispose of the batteries responsibly as you would any batteries.

The batteries are just 2 rechargeable Ni-Cd AA's, soldered together at one end to form a connection. I popped in two regular AA batteries, formed a connection between them, and it started spinning again!
To open up your shaver, remove the lotion cover and remove all 5 screws with a small flat head screwdriver. They have a star head, but also a flat notch. Since they shaver is water tight, the first time you open it up it will be difficult, but if you pry off with your screwdriver it should pop off.
Towards the head of the shaver the batteries are soldered to the circuit board. Pull the tail end of the batteries out of the plastic holder and cut them at the top end as close to the batteries as you can, or CAREFULLY bend it back and forth to snap the metal. Dispose of the batteries responsibly as you would any batteries.

is there a sticker at the back of shaver? try to checkout the hole at the sticker, that is the screw, or you can open the unit by unlocking the side locks by cliping out the locks!