20 Most Recent Bradford White M240s6ds-1ncww 40 Gallon Electric Water Heater - Sh Questions & Answers

1) Copy following links:http://waterheatertimer.org/How-to-adjust-temperature-on-water-heater.htmlhttp://waterheatertimer.org/How-to-test-water-heater-element.htmlhttp://waterheatertimer.org/How-to-replace-thermostat-on-electric-water-heater.html2) if you have electric water heater, and too much hot water, then thermostat may be bad, or element is shorted and needs replacement. Test elements first, and if they're ok then replace both thermostats. If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Doesn't sound like its the dip tube, its a element problem, I would contact bw directly to see if heater is stil in warranty and they will send you new parts free.

Sounds like the TCO is tripping .../. because temperature inside burner is higher than 180° Replace TCO ... and it problem is not fixed, replace gas control valve thermostat http://waterheatertimer.org/troubleshoot-gas-water-heater-thermostat.html

Replace the motor

Copy following link for replacing thermostat.http://waterheatertimer.org/How-to-replace-thermostat-on-electric-water-heater.htmlSuggest you might also want to test the elements while power is turned off, just in case the problem is element shorted to ground across metal tank to ground wire.http://waterheatertimer.org/How-to-test-water-heater-element.htmlAt least you know the 240volt power to water heater and the circuit breaker are good. If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

I am not sure they are available to non Hitachi service centres. https://documentation.hitachiaircon.com/glb/en/pac/rua-at3s

Cannot find the fault code . There are vidoes on u tube saying how to reset thr code By pressing the reset button . If this does not work youcan ccontact vaillent on there web page . I have a mate who works for them i will ask him as well

Do I need to insulate this heater out in the shed? Freezing temperatures

Call a engineer

The P8 fault can mean many things when it pops up on your Mitsubishi Electric wall controller. The P8 fault is activated when the indoor coil sensor does not change the temperature for a set amount of time after the compressor is (or should be) switched on.

Where does the tube sensor go

This one looks the same.https://www.ebay.ca/itm/133397559348They are made by Harper Wyman and using that model number, this is the result.https://www.google.com/search?q=Atwood+RV+oven+control+valve+57294But this shows more that looks similarhttps://www.google.com/search?q=Harper+Wyman+oven+control+valveAnd then if we go here and Zoom in, you will see MTZ 22300https://youngfartsrvparts.ca/products/used-atwood-wedgewood-oven-thermostat-57294Which leads us here and the Specs Sheet.https://www.copreci.com/en/gas-cooking/product-range/thermostats/with-safety-and-thermostatic-flow-regulation/372-mtz-22300-seriesand from there to here, and Parts Town stocks them!List Price: $ 318.24https://www.partstown.com/fagor-commercial/fgrc12008712..

call plumber to replace gas valve, it may cheaper replace water heater. gas valve is not DIY

test for sticking relay faulty circuit board or faulty stat