Top 20
Blomberg BRFB1150 | 11.7 cu. ft. Counter-Depth Bottom-Freezer Refrigerator - Stainless Steel Questions & Answers
Bloomberg freezer error code e9
www.appliancevideo.com/repair-help/question/
error-
code-
e9
The unit keeps getting a low water error and everything I could think of checks out: inlet valves, w. ... Error Code E9 ' Appliance Video .... Ice on bottom of freezer
7/23/2015 12:16:08 AM •
Blomberg...
•
3,924 views • 0 helpful votes
Blomberg dishwasher door falls open, no resistance to the floor
Blomberg machines are special. The insulation and access to side parts are concealed. The dishwasher is encased in stainless steel panels, so you actually need to totally disconnect and remove your d/w for this repair. I bought the little parts, nice and cheap, but I am not going to uninstall and reinstall the entire unit for this little inconvenience. I am going to fashion a swing-down door prop instead.
12/28/2016 5:51:02 PM •
Blomberg...
•
2,960 views • 0 helpful votes
Dishwasher is powered on but and making normal start up noise but no water is entering the dishwasher and not beginning the wash cycle
My Dishwasher is a Blomberg DWT 25200 SSWS. It had the same problem. It powers up but no water enters in it and the clock didn't advance. This is what I did to fix it. You can display the error code by powering off the dishwasher then pressing the 'Program' and 'Half Load' buttons at the same time then power on the dishwasher. This will show an error on the screen. My error was E:1. The problem was a disconnected blue hose at the bottom of it.
This is the overflow detector.
This little board has a 12 Volt relay that activates the main water valve which is a 120 VAC valve. There was nothing wrong with it.
This plate is at the bottom of the dishwasher to hold the water that spills.
5/7/2015 12:08:36 AM •
Blomberg...
•
1,525 views • 2 helpful votes
Dishwasher washes dishes but does not dry even though that display shows dry icon
First ,Check for a water puddle on the bottom of the dishwasher .If you have water there, you more than likely have a plugged drain or drain hose, or bad drain pump (less likely) If no water is there see if the dishes are hot after a cycle. If they are not you could have a bad heater (that circular thing on the bottom of the dishwasher) other problems could be the timer or computer Depending on the model brand and age of the dishwasher .One last thing there is a vent to let moisture escape that could be bad but then you would have hot wet dishes
8/7/2014 4:09:15 PM •
Blomberg...
•
582 views • 0 helpful votes
Not finding what you are looking for?