20 Most Recent
Euro-Pro Shark GI490 Iron - Page 2 Questions & Answers
The power cord on my
Hi!!
It should be an access plate fasten by a couple of screws right below the power cord, remove them and fix the cord's terminals/contacts or the cord itself.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.
Iron will not stay on
More than likely your power cord has a broken wire. Plug the iron in and mover the cord around. See if you can find the broken wire. Typically where the cord comes out of the iron and right at the plug. Or replace the whole cord. Your local hardware store, youtube, or menards can show you how. Very easy to do. I tend to stay away from home depot.
I have a Shark automatic
you prolly have a 1 year warranty, return it to walmart or they will have the address of the local repair depot or contact shark for the local repair depot they use
I can't believe you charge
on this and any iron that requires water use
distill water it is free of minerals that way your iron is always clean and free of any sediment.
Patio door won't close flush with opening
What is a flush door, where is it used, and how is it constructed. Flush doors are commonly used in houses and security places.Metal flush doors are commonly used in higher security settings in motel construction where every guestroom can be accessible via an open-air catwalk.
No power from cord. I want to replace the cord.
In replacing the cord, you have to remove the screw that holds the back cover and unscrew the damaged cord from the heater terminal. Insert the new cord on the rubber insulator and screw it to the heater terminal.
How do you open the back of an iron
the best way is to use the little screwdriver for to open with the help of some plier. Or use the tools for open the back light in car, is the same type .God bless you
Shark steam iron
I always purchase your Product and Irons. I like your product very much. so please provide me with address to sent this Iron back for repair. It has always made the lights in the room whenever I Iron go on and off. Also shuts off and on during ironing, then and water leaks from the iron. " Please Help"
Martin
DISASSEMBLE SHARK G1465D ELECTRIC IRON
there are 4 screws that you can see and two more under the large rubber stand off at the bottom. I also need you post the wire in the back because I took mine apart and now don't remember the position of the wires
Our iron keeps shutting off
the brown liquid is rust from leaving the water in the iron. Always dump the water out when you are done ironing. You need to run a descaler through it. you can purchase descaler online. The shutting off and on could be a loose wire.
Iron quit working in less than 1 year.
Bought my Shark G1400Z iron about a year ago. The iron caught on fire. Luckly I was only out of the room for a few seconds. What can be done about this?
Iron does not get hot
Mine just did the same thing, I think the controller fried. There is aburnt smell coming from it
Not finding what you are looking for?