20 Most Recent Fisher and Paykel WA37T26G Top Load Washer - Page 2 Questions & Answers

the lights are a fault code, this will help with diagnosis. check your motor for corrosion.

That is fault code 43 43. (00101011) Phase 1 to 6 - OOB Switch Fault The Motor Controller module has found that the signal returning from the out of balance switch indicates that the switch is permanently on or the harness to it is disconnected. Primary Source: Mechanical. Action: 1) Check that the out of balance switch is free to move. 2) Check that no harnesses are blocking switch movement. 3) Check that the switch operates correctly when activated. Replace the switch if suspect. 4) If the out of balance micro switch shows signs of corrosion, replace the switch and switch harness, and fit a condensation kit to the console area if not incorporated in the top deck. 5) Check the level of the machine and also the bias spring. Secondary Source: Wiring. Action: Check the harness to the switch is connected correctly. The terminals should be connected to the normally closed position. If the harness terminals show signs of corrosion, then fit a new harness.

That sounds like the pump is jammed and did not pump all the water out.

250. (11111010) SmartPump Loss Of Sync This fault is normally as a result of the pump not starting. This fault is usually caused by an object that has gotten into the pump, and is either under or on top of the impeller, which is causing the motor to stall when it is trying to start. Primary Source: Pump Stator Windings Open Circuit. Action: Measure the resistances of the pump stator. For more information refer to the AquaSmart service manual. Secondary Source: Pump System. Action: Follow procedures as for Fault Code 249. Tertiary Source: Motor Control Module. Action: Replace Motor Control Module.

There is no code for 31. To work out your fault code just add up the lights that are on.

Yes a 4amp fuse in the brown motor controller board.

You will need a technician to fix this,

you have blown the fuse on the main board. you will need to check short circuits in your pump and motor, and for leaks onto any electrics, and then replace the motor control board (or try to replace fuse on board if other components look fine ie no burn marks)

sounds like a valve fault. this fault can be caused by the electronic board not powering the valves also. check power to valves during fill, if power, replace valve. if no power replace board.

have you got the hot water pipe on? the water can sometimes flow back out this valve if it is not plugged. has it been serviced recently? there is a pressure pipe that attaches to the side of the bowl, and a pump that need to be secured or you will get a leak from the bottom. if is has become loud on spin recently, it could be that you have a leak from the main seal, and will need bearings replaced aswell, but that model seems a bit new to need bearings already, but it's not impossible.

Make sure the load is even. If for example heavy towels are on on side and thinner clothes on the other, that would cause the knock.

sounds like a diverter valve , located under the unit on the back right or it could be you pressure sensor .

Does your machine have a diverter valve,If it does the valve is stuck in recirculate mode.Lint has jammed it closed.