20 Most Recent
Canon iR 2016i Black and White Copier - Page 3 Questions & Answers
Display shows "system Error E007"
This is a error on the fuser unit (E007 Fixing film rotation error).
The fixing film sensor is faulty. - Check the connector of the fixing film
sensor.
- Replace the fixing film sensor.
- Replace the DC controller PCB.
Normally you must change the fuser to resolve it.
Bye
I have been using Canon
there is a one white patch sensor on the fixing film, if this patch sensonsor can't read by fixing unit. machines will show E007 error because of fixing film broken.
so you requie to replace fixing film.
Copier model canon ir 2016 (down load stand by )
hi if yo have knowledge on electronics try to remove the boot rom and memory and let the machine for 10 minutes,then put it back the memory and boot rom,and turn on the machine.if the same thing try to update the firmware using sst
Sir I have canon IR2016J
Hello,
first, do you copy from second drawer or bypass tray or first drawer?
Open the left door, in lower section open the paper cover. Now remove drawer. If You look from the left door side beneath the drum unit, you will see axis with 2 rollers, CLEAN them with alcohol or water by rubbing them, and dry them with dry cloth.
Also if you look little closer beneath the axis with rollers you will see the two rollers ( grey, one above the other ) clean them also or replace them if the rubber on them are too smooth.
If the problem appears when copy from second drawer, i.e. A3, you need to replace the pick-up clutch!
If the problem appears when copy from bypass, clean the bypass feed roller.
Hope that something of these helps you!
Help
This means the printer booted in download mode. There are problem with the firmware.
You will need the support tool and a software cd for that model.
Please consult further with your manual on updating firmware or call the Canon tech to get the firmware updated.
How to clear a full memory?
try going to the control panel of the computer, click on printers and hard ware , click on the printer , right click on the properties and see what data is ready to be printed
high light each line and end task
Paper jam problem
Replace the paper pick up & paper feed & paper sep. rollers in the paper tray... Good Luck
Not finding what you are looking for?