20 Most Recent
Sharp MX-2300N Color Copier - Page 3 Questions & Answers
How do I scan a
Put your paper in the document feeder. On the LCD screen touch the button that says 2 Sided. Then touch the one that says 2 to 2.
HALO I Wanna to know sharb service mode?
Yes the Sharp Mx2300n has service mode. To enter service mode you will need the original admin password, this password 9 times our of 10 is admin.
Step 1: press SYSTEM SETTINGS button on printer
Step 2: At the top right side of the screen is two buttons 1 Admin Password 2 Exit. Press Admin Password.
Step 3: Press password button
Step 4: type admin (no caps)
Step 5: press OK
And remember to sign out when your done. I hope you enjoy your sharb printer, I certainly enjoy my sharp it's a good one yes.
McHaggerty out
How to change settings to tell Sharp MX2300 that it no longer has a finisher/stapler unit.
Does it show the finisher onscreen? or are we just talking about when printing to it.
once you unplug the wire harness for the finished and power cycle the machine using the main power switch it should no longer display a finisher on the screen.
You need to change the configuration of the print drivers on your computer to remove finishing options when printing. right click on the copier in your devices and printers and go to printer properties. Go to the configuration tab, and click the button for auto configure. some little fingers will pop up and tell you what to select click ok and then apply.
Let me know if you are still having problems I’m happy to help further over the phone at
https://www.6ya.com/expert/ethan_e84416e0b13809d2
What is sub code of fk1
FK1 refers to the maintenance life counter for the fuser unit.
The fuser rollers have a fixed life count & when that count is reached FK1 is displayed. If the rollers are worn they should be replaced but if they are ok you can reset the fuser maintenance counter in SIM 24-4 FUSER UNIT
We have a spooling problem. The sharp mx-2300n
Go into the Job review mode and highlight the pending print job (note: it may be stuck in processing). You should then get the option to delete the job.
Make sure that the pending print job is also cleared from the network print queue. They can sit in the queue and be persistent on processing, even after you've cleared the copier. Clear the queue prior to deleting the job on the copier.
If this doesn't, disconnect the copier from your network and try the above steps again, then reboot the copier and reconnect it to your network.
If you're trying to print out Adobe-based web pages from the internet, this may be what's causing your copier to jam up. There's known coding anomalies with Adobe-embedded documents on web pages. Trying to directly print from the web page can stall or lock up the print process.
Mx-2300n firmware
The firmware is only available from a dealer. You can make an arrangement to get it on a USB thumb drive and update the machine using SIM 49
Says printer offline
"Offline" means it can't connect to the printer. Check all the wires from computer to printer, unplug and re-plug. Unplug printer from wall, wait 30 seconds, plug back in. Make sure printer is on.
How to delete code H5-01
hi there can be possibly 2 kind of problem soft reset for malfunctioning
and other one physically damage so both are expand blow
1. soft reset H5-01
to clear it with numeric key panel just press the numeric keys in sequence P, *,C, * and 1,4 and start it will clear the error code.
2. physically damaged parts checkup .
usually h5-01s i get trace back to the white gear on the back of the ITB being broken where the pin seats into the gear. take it off and inspect the other side of that drive gear.
if the jam is stationary there could be a path obstruction or something involved with the drive not working. run motor checks on the fuser as well. does it turn freely?
Not finding what you are looking for?