20 Most Recent
Sharp MX-2300N Color Copier - Page 4 Questions & Answers
Factory set
Enter admin setting from panel and reset to defaults
There is an error on
G'day, I know the answer from much investigation. you see I had the same problem "Remove paper from center tray". This fault occurred after a weekly wipe down of all moving parts to prevent the print rollers from becoming "Sticky" (with residual toner). I could not work out this fault I read the above answer and spent at least 40 minutes pressing prox switches and messing around with tray setup, and nothing the fault still appeared. then I decided to read the manual, and... Guess what NOTHING on the specific "Remove paper from center tray", but what I did find is that the "Center tray is non other than the Output Tray, you know, The Spot where your new fresh printed paper comes from. If you get a torch or light and look inside you will see two leavers (one double leaver and one single leaver). The single middle leaver is your problem, it senses to see if the "center tray' is full so that it can stop printing to avoid a problem. this center leaver comes unattached, all you need to do is clip it back into its home position. Straightaway your problems will go away. Cheers McHaggerty
Derp
Derp 101: Please state your category of problem. Misfeed, Error Code, Maintenance Required Code, Can't Print, Won't Scan, Lines on Copies or Prints, Bad Print Quality, etc, etc,
Not finding what you are looking for?