20 Most Recent Kenwood KVT-512 Car DVD Player - Page 4 Questions & Answers

in order for you to see movie or vedeo you need to connect pink or bronw wire to ground witch that allow to see inmage.

brown wire is probably telephone mute, light green is parking brake

it sounds like the "remote wire" on the amp is coming from the "power antenna" output of the radio instead of the "remote turn-on" wire or in the case of kenwood, the "power cont." wire. Sounds like that's whats happening.... switch the wires on the kvt-512, should be a blue wire and a blue/white wire. hope that helps, dave

There should be a wiring diagram on the top side of the stereo. Normally the brake and reverse wires are separated from the other wires so it should they stand out. On my stereo. One was pink the other light brown.

Baadaye

Get your manual here:
http://www.retrevo.com/samples/Kenwood-manuals.html?cmpid=Manuals_Kenwood&s_kwcid=kenwood%20manual'4347047931&adsense=2257534859&gclid=CNiGqsOdwqQCFQpe7AodOD_EEA#Car%20Video

Open the manual for your player, and go to page 27 (JPEG picture control.)


Good luck. don't forget to vote.

When i put in the Cd it shows up Messsge Error on the screen

Mecha error

try checking your speaker wires for shorts and bare spots. also check to make sure you have no shorted or bad speakers. if they all check out good, you may have a bad output ic.

Yes,scroll throught the audio selections and turn the sub output on.

Hi...
usually these types of gadgets are blocked by the anti-virus or firewalls... So disable anti-virus program and any personal firewalls if any.... and connect the again,,.,..
And also ensure that the USB cable as well as usb port is working well.. also enable synchronization from your gadget...
Hope this has helped you... Thanks...

is your deck a remote control operated? you can use it if you have.

you are so close your gonna hate youreself a lttle your connected to the blue power antenna wire connect it to the blue white remote turn on and your all done

you need to remove the radio from the dash. the model should be either on the top or bottom of the deck.

Check the documents that were given to you by the dealer of the other car and look for a card that contains the code. If you could not find any code, get the serial number (usually located underneath) and then contact either the dealer or the manufacturer of the other car where the Kenwood was originally placed. Either the dealer or manufacturer could give you the code.

The code that you need is also called the "anti-theft" code and it's unique with every car radios and DVD receivers. So only the manufacturer could give you the code that you need. It's designed this way so that the appliance would be useless once stolen.

Thank you and good luck!

Sorry...KENWOOD codes are only available from the Main Dealer or a Radio Decoding Service

It might have taken a small short. You can push the reset button just to the left of the volume buttons. Good Luck.

Hi I would suggest you need to call or get in touch with kenwood corporation they are the only one that can reset your password but you have to show proof that it is yours.
good luck