Top 20 Canon Pixma iP2600 Photo InkJet Printer Questions & Answers

could be a faulty ink cartidge.. try a different one if you have a spare... or even put the old one in, and see if the mesage changes to empty cartridge,,,

http://www.manualsprinter.com/manuals/canon/Canon_PIXMA_iP2600.pdf .found this manul not sure if it will help you out.

If you wish to get some details about printers an copiers error codes and repair ; check the site linked here. Pull up older posts... http://electro-medical.blogspot.com/

There is probably dirt on the rollers or on the paper carrier. You could try running the printer through a self clean first. Go into the printer settings, menu, locate self cleaning and press that.

Make sure you remove the protective tape from cartridge(s). If it's been removed, try running 'nozzle clean' or 'deep clean' (for that cartridge). You can find this in 'Printer properties' on 'Maintenance' page.

If catridge is in reach of your fingers then pull it back otherwise you have to open the chasis screw of the printer and pull out upper cover and rotate the belt and you can then make printer workable

turn off and on the internet and it should start printing if not, press print button again and it should work

sir, u replace ur cartridge if no than carriage assembly.

The printer is probably asking for the ink uptake pads to be reset. http://www.fixya.com/search/p922048-canon_pixma_ip2600_photo_printer_inkjet/ink_pad_reset

download them from here http://www.canon-europe.com/Support/Consumer_Products/products/printers/InkJet/PIXMA_iP_series/PIXMA_iP2600.aspx

since you have not used it in a while, the ink has dried. You will need to clean the machine, check if cartridges are ok. Also see troubleshooting in the manual.

Verify the connections and if OK enter in the printer menu select the maintenace mode and follow the steps.

check that the cord is fully depressed into the back of the printer.Is power coming through? will it function, if so then it is the led inside the printer.

Please check if there is not some dirt, or something blocking the contacts from reading. Also the ink level is measured by optical sensor that can also be dirty. Also make sure you use an Original Canon cartridge. It could be the chip on the cartridge has either gone bad or could no longer be reset. The chip is what tells the printer that it is ok to print (i.e. there is ink available and that the cartridge is approved). Some chips will only be reset with available procedures a few times. Other times refillers are not succesful in resetting the chip or just give you another cartridge that is already refilled and could just happen to have a bad chip. You should probably return the cartridge and try to get one that will work based on the argument that refilling is not only related to ink but also to chip. Otherwise here is a web site that has a special page for your Pixma that contains all possible refill products: http://www.inkfilling.com/inkjet-refill-... Source(s): http://www.tonerguru.com

ip2700 can print an A4 photo.

Blocked print head nozzles Inkjet printers need to be used frequently to prevent blocked print head nozzles. You may have blocked print head nozzles. Try the printer maintenance to clear the printer nozzles. After several deep cleaning attempts and there is no improvements in the print then a new print head is required.

if its the correct cartridge for the printer take it out shake it and try putting it back in, if no luck its a faulty chip on the cartridge just needs to be returned to the shop.

have you tried cleaning the printheads ? There is an option for cleaning head in printer's properties : select this and you will be able to clean printehads for the canon iP2600

hmmm as in a reset to the left that usually happens only on start up from nothing and then it settles in middle