20 Most Recent Ryobi Cultivator Questions & Answers

Check the oil in the gear box.

I had the same problem, the engine ran but the tines would barely move on my Ryobi tiller. There were 2 plugs on the gear box. I removed them with an Allen wrench and added oil until it leaked out, replaced the plugs, waited awhile and started it.That fixed the problem, it worked fine.

If you can't find one could I buy the carb? Or just the float gasket. That would be awesome. My email is [email protected]

Look closely at this exploded diagram. It appears the piston 'relief' goes to the flywheel side. Ryobi Tiller 410r Parts List

Have you checked to see if the outer throttle cable is properly seated at both ends?

I have the same problem. Can't find the cam anywhere so I'm going to make another one.

50:1 is the recommended. I hope this helps.

yes i would like to have one too. that way i could post it for you . but i don't sorry.

-Most small power equipment's spark plug are pre gap. You don't have to. Good luck Mai

Most small engines are gapped at .028"