LG DLE2512W Electric Dryer - Answered Questions & Fixed issues

Post a photo

Check for broken belt. Take top off to check.

remove screws in back, slide top back about four inches, left off.

never lubricate a drum roller ,it will attract lint and hold it like a magnet possibly making your problem worse. graphite lube possibly - as used in door locks.but this will be only a temporary fix. replacement is the only way to go.

Reset your electric breakers and make sure the door switch is working. If not sure on switch after resetting breaker turn dryer on and with open door press the door switch in .caution keeps hands from inside in case it starts to work It also could be a Senser inside of dryer that goes off if vent is plugged with debri

bad belt or worn out drum wheels

the band either came off or broke

I have a washing machine error detection 3E

Here is a list of dis-assembly videos to help you out.

Comm error between the control panel and main control boardService ManualLG Dryer error codes If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

if the motor is running and the drum is not spinning check the belt that wraps around the drum and motor. may have broke or just slipped off

sounds like your condensin pump is leaking and triggering the over flow micro switch not a job 4 a novice call an engineer good luck

Do you mean LE? Because a LE code means Overload in Motor.

Not sure but it sounds like a bad control board. You may have to replace it.

If you have chosen the manual mode and the dryer works well , then the fault can be with the sensor. need to check if there is false reading or if the control board has a issue.Try to clean the unit and reset for a trial.

There was no comment of the fault that was seen on your machine and so would request your observation.

Hi, Yes, it needs it's own line...Yes you can plug it in to a 240v outlet...

Here is a tip that will help you with changing your dryer plug. Dryer Cord and Wiring Dryer 3 Wire or 4 Wire



heatman101

here is a copy of the service manual of that model   http://136.166.4.200/contents/Laundry/DLE2512/DLE2512_Service_Manual.pdf

You may have a high limit switch that has failed. You will need to tear down the dryer to get access to the heating element. Look for the heating element on the bottom right side. There are 2 thermo discs located on the left side of the heating element. Test both of them. If there is no continuity, change that part.
Hope this helps.

Hi,

Here is a tip that I wrote about why an electric dryer will not stop heating sometimes.

Electric Dryer won't stop heating

heatman101