20 Most Recent LG WD-1280FHD Front Load Washer - Page 2 Questions & Answers

Door switch assembly is faulty, check and replace if necessary.

I see a little confusion here...there is LG WD-1280FHD which is the MODEL number, WD= washer-dryer, LG=Life's (not so) Good. The "F" is for Front Load... HD for dryer Heated Dryer. The numbers correlate to date and assembly plant location. IDK this other number your showing is a Part Number If you need further help, reach me via phone at https://www.6ya.com/expert/steven_b77d19396bfe2249

Fault code 130 means the RPS (rotor position sensor) is not sending correct signals to the control board. The RPS is a small electronic device mounted on top of the motor copper stator. Either the wiring plug attached to the RPS has corroded the contacts or the RPS needs replacing. You will have to lie the machine down on front face to access the motor. Unscrew the centre bolt and remove the outer rotor bowl, then loosen the 4 hex. head bolts holding the stator about half way. Pull stator down so you can remove the wiring plug from RPS. Check for corrosion. If no corrosion then remove & replace the RPS.

SWITCH OFF AT THE PLUG, AND BACK ON AGAIN

with the inlet valve filter may be block..

Did you turn off the outside valve? Will water come out of the hose if you remove it from the washer?

check the water inlet valve. http://www.youtube.com/watch?v=i5nygF7meKQ

Try this. reset machine. start a quick cycle. Once the pump starts, open door and add 2-4 cups of water. close door. If machine starts to work the the water inlet valve needs to be replace.

door sensor need to replace or if you can easy to repair usually plastic part is broken

Remove power for some time , allow the power to drain off the memory and see if the display is clear. If not hold the start button and switch on power. Check the inlet and drain filter , free water flow, if not remove and clean.

Hello,Try downloading manual HERE If this information it's useful, please rate it.