20 Most Recent
Samsung LN46A650 46 in. LCD HDTV - Page 6 Questions & Answers
My LCD tv model LN46A650A1FXZA picture turns green
I have the same issue. TV is ~ 2 yrs old. Ruled-out cable-box & HDMI cables (green present in menu mode with no cables attached).
Screen turns mostly green, with a crappy picture. After a few days, a normal picture just appeared. Today I powered-on, the green screen stuff came up, then a minute later a good picture for about 20 minutes, back to green-stuff for 10 seconds, then good picture.
Did chavez_debi get her issue resolved?
I NEED TO KNOW HOW
http://www.scribd.com/doc/12736526/Samsung-LN46A650-LCD-TV-Manual
Go to this link and scroll down to page 100. Hope this helps
My television hesitates when it
Sounds like there may be some bad electrolytic capacitors on the power supply module. This has been a common problem on for this model. There are 2 caps that are 1000uf / 10 volts that commonly go bad on this set. All caps on power supply module that are domed or mushroomed on top rather than flat will need to be changed. Eventially it will get to where it will not come on at all if not fixed soon. If you have any experience working w/ electronics, this a very simple and inexpensive repair to make.yourself. If you take it to a shop, you'll probably pay anywhere from $100-$200 to get it fixed, if it is indeed bad capacitors. If you need any more info just let me know. I've repaired many lcd's w/ this problem before. I would definately start by checking the caps. If you do it yourself, make sure you put them in correctly. You have to make sure the positive/negative pins are in the right position as it's printed on the board.
Samsung tv series 6 650 won't play vhs
Steps to view a video tape:
1 - connect the vcr to the tv using the appropriate cable - in your case a S-VIDEO one.
2 - select the S-VIDEO as a source in the tv menu.
3 - press PLAY on the vcr's case to start playing the tape.
ROLFMAO
Samsung 46
The Tuner board have problems.That the board where the coalax broscast signal plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish Tuner board for the replacement.
After being on for about 30mins my Samsung Series 8
Since unit is less than 1 year old, it would be covered under Samsungs warranty. Call 1-800-samsung and they will set you up for repair with an authorized service center. Your problem could be caused by a bad power supply board or a bad main board.
Daytek DT4660 - at ac on , led grn for 2-3 secs,
Hi
I work on Daytek 4660 models. I have seen the problem you are having and have solved it a couple of times by replacing all the capacitors in the power supply. If you use an oscilloscope to measure the voltages they may appear fine, however I have solved this problem by replacing all the capacitors in the 2ndary circuit of the power supply. It doesn't always work, but has worked in about half of the TVs that have come in with this problem. Also, just to make sure, if you remove the shielding from the board that drives the LCD panel make sure the little smt fuse is good. It's right on the 5V power line close to the ribbon connector from the main board.
Our tv will not go on and there is a clicking
I think it is the 12V source have problem, it need measuring on the circuit, the power supply; main board; t-con board could cause that problem.
Knowledge obtain from: Real case of repair by myself.
I have a Samsung Series 6-650 LCD TV (Model #
Why do you use VGA-HDMI cable? This TV works fine with VGA cable - it has VGA plug.
Or if your notebook has DVI output, then you can use DVI/HDMI cable and connect it to the TV to plug named DVI/HDMI (only one HDMI input is marked as DVI on TV).
I suppose that over HDMI the TV supports only some standard resolutions, but over VGA it supports almost every resolution laptops use. You can find supported resolutions for each input in the TV manual. Try setting the same resolution on the laptop.
Not finding what you are looking for?