Toto Aquia II Dual Flush Toilet - Answered Questions & Fixed issues
Toilet buttons will not come back up, hence water keeps running
Could be a few reasons, an ill fitting or cracked dress cover can sit to low, or abrasive wear and tear can grip the button restricting it from free movement. I fixed mine by placing a couple of small fishing sinkers in the bottom of the plunger giving it a little more weight.
Push Button - Have to Hold Down Button
I had the same problem. The fix cost me 50 cents (literally). I just placed a quarter on top of the Blue and White flush buttons (not sure of the technical terms) inside the tank and now it flushes properly. It seems that the 2 plastic poles the extend from the faux chrome buttons are just a bit too short.
Hope this helps
11/2/2013 12:13:32 PM •
Toto Aquia II...
•
Answered
on Nov 02, 2013
•
11,503 views
The toilet see is not
Hi,
Right behind the bowl on the underside there is a nut on either side that holds the seat on...tighten those nuts and it will tighten down the seat...
heatman101
1/29/2013 9:47:30 AM •
Toto Aquia II...
•
Answered
on Jan 29, 2013
•
6,431 views
Leaks when cleaning the bowl. Bowl moves a bit.
Leaks at the floor or the tank where it meets the base behind the seat?
Generally tight enough to sinch it so as not to leak.
If the whole unit moves on the floor the wax ring may need to be replaced. If the tank leaks be sure the bolts are tightened evenly with new gaskets sealing them inside the tank. Tighten the nuts evenly until it stops moving freely and the leak should stop.
How do you put the toto dual flush parts back
Very carefully!!!!!! Why would you take it apart not knowing how to put it back together again?????? Take pictures next time, after you call a plumber to put it back together again Humpty....
The refill valve will not stop running
I'm afraid that there is little that can be done other than replacing the valve when they go bad. You should try to adjust the water level, but usually the best thing to do is to replace it.
Best regards, --W/D--
How do you connect the
If the factory end is no available a quick fix is a paper clip. You will need to adjust the length of the chain.
Not finding what you are looking for?