Top 20
Craftsman 42 in. Deck 19.5hp Lawn Tractor - Page 2 Questions & Answers
Fuel line schematic model 461707
opposed twin
carb mounted fuel pump... ???
is it a three or four screw pump ???
it's been a while but I think it's a single hose to the pump. the three bolt pump has a pulse hose on the bottom of it...
I need to installhow to install a new deflector on Craftsman mower model 917273130?
Very simple. The 6 inch or so pin that holds it on is retained by a clip on one end. To remove clip use a pair of pliers. If you work steadily and carefully you will be able to reuse this clip. After removing clip, pull the pin out. Old deflector and spring be removed now. To get the spring right you have to try it in position before installing it. Just remember that the spring is holding the deflector down so when you are done installing, when you pick up on the deflector there is pressure holding it down. Don't put the pin clip on until you verify the spring force is correct because getting that spring clip off is the Hardesty pay off the job.
MTD 42" zero turn transmission belt jumps left pulley on start
A little wd40 on each pulley arm assembly, make sure they move freely and good time to check the belt and belt brakes if equipped.
I assume your belt was recently removed or installed and is not following the correct pattern. Is this the issue ?
It's very common for people to install their belt around pulley in different direction and belt is not ( or is ) riding on the Idler pulley, other, or guides incorrectly.
Under the chassis somewhere is a label for belt pattern and is usually under the left side foot grip of the chassis.
( Lifting the mower ? )
Be sure to have some chunks of wood available. I use 2x4 and 2x6 scrap to hold up the machines without use of jackstands or any jack which causes damage.
Replace belts on 917-271821
The deck has an idler pulley that keeps tension on the belt. The idler pulley is mounted on a pivoting bracket, that has a spring which provides the tension. You have to move the bracket so as to take the tension off the belt, thereby allowing you to slip the belt off the other drive pulleys
How do I replace deflctor shield
You have to hold the spring and deflector in the loaded position (forcing against the spring force) while you feed the pin thru the deflector and spring and back thru the deflector and intor the deck bracket.
Rear oil leak is how do i replace seal
Part Number AYP 583300901 supercedes 407129 for the DANA 7088 transmission.
As for replacing it usually requires opening the transmission case as they are usually recessed in the casing. Reseal case with RTV Ultra Grey sealant
Mower wont engage bland to turn
Do you mean "mower blade won't turn"? This could be a broken or slipped belt or possible a damaged mandrel on the mower deck.
How do I remove a valve stem from riding mower rim?
If your simply replacing it with a new one or installing an inner tube you take a sharp knife and cut back side off. Don't cut completely as you want to catch that piece before it falls inside the tire. Then you simple pull the stem breaking that piece off, catching the back piece as it falls.
If you wanting to put back in a new stem for tubeless use you need a t-shape valve core wrench. After you place the new stem in the hole you thread the tool on and pull the new stem into place.
Not finding what you are looking for?