Top 20
Craftsman 42 in. Deck 19.5hp Lawn Tractor - Page 6 Questions & Answers
Wizard 42" (Craftsman) lawn tractor transmision
if the trany is locked up u will have to remove the trany
most the time its the needle bearings on the input shaft
there 10-15$ each takes 2
but trany has to come aparts
they are fairly easy to open n fix them
Uneven mowing
first make sure left and right sides are same height. Next, adjust front and back heights per users manual. If still off, make sure you dont have a bent blade or bent or missing front or rear deck link.
Craftsman 27 hp 48 inch tractor blades only engage
Probably a safety switch gone bad. Check the battery a functional yet weak battery will cause many weird electrical issues even if it has the juice to run the motor it can lack signal to smaller components making you scratch your head in confusion. That's a simple fix worth a try. If not that then check grounds, fuses, safety switches, wire condition and connections.
Hello. Ran over a softball-sized rock with my
Could be a safety switch but it sounds like a bearing or shaft is seized up due to the accident. First thing I would do is to remove deck belt and try to spin each blade separately by hand. By isolating each one, spinning one at a time you will be able to tell if your problem lies in the deck. If you have one that wont move the spindle assembly will need to be replaced. You may want to take a picture or sketch a diagram of belt routing before you remove deck belt to assist in reinstalling the belt when your done. Also, remember to do this with engine off. Good luck and happy wrenching! I’m happy to assist further over the phone at
https://www.6ya.com/expert/layne_0fccff498c319c32
Belt on craftsman 42" riding tractor
There should be a decal on the deck with the diagram. To change, first remove belt from engine pulley.(front pulley under emgine) and go from there.
Not finding what you are looking for?