20 Most Recent Bowflex Treadmill Series 7 - Page 8 Questions & Answers

Hi There, No, all treadmills require a safety key for users that could fall or become tangled in a running machine. Most safety switches are simply a magnet that closes a Reed-Switch inside the console, some are a bit more complicated. Replacements can be found for these keys. Contact [email protected] for more help if needed. Good Luck

Please follow the link for possible repair procedure. TREADCLIMBER tc5000 error code L5

If you wish to get some details about treadmill repair ; visit the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

If you wish to get some details about treadmill maintenance ; visit the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

Try to lubricate the Running belt first. check the video to know how to lubricate the running belt. Treadmill walking belt lubrication If you wish to get some details; visit the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

Hi There, L5 error should refer to the "LS" error which looks up to a speed problem. When you start the machine up, it boots fine and then when you press start or go is says err ls ? If the walking belt doesn't move at all when you try to start it, listen for a "Click" on that lower board when start is pressed..... If the walking belt moves for a second and then stops and the console says err ls, then you may have a speed sensor problem. These control boards are repaired by Jatinah Electronics who can be found with a google search. Good Luck!

Plug power cord into wall outlet and turn on power switch. 2. Stand on the side foot support platforms or rubber floor mat. DO NOT STAND ON THE WALKING BELTS. 3. Insert the Safety Key. Note: The Bowflex if the Safety Key is not fully inserted into the safety keyhole. 4. Press and hold hold "ENTER" and "POWER" for 3 seconds while the Console is dormant. The word "CAL" shows on the display. 5. Press "START". This enables display of maximum speed (with unit of measure) and maximum incline. 6. Verify correct units of measure (English imperial/ metric). Press "START" to change from one type to another. Press "ENTER" one time to set the measurement unit. 7. Press "START". 8. Press "POWER" again to save and exit, once calibration is complete

Yellow pages should have that or their website.

You have to check the running belt tension also the rollers Of you wish to get some details about treadmill belt adjustment then check the following link http://electro-medical.blogspot.com/