Sportline 345 Electronic Pedometer - Answered Questions & Fixed issues

To replace the L1154 battery, pull the back cover off using the notched plastic lip. The battery slides out laterally by slightly lifting the outer notch on the battery holder.

Try http://www.sportline.com/manuals/228.pdf for instructions.

This is link is updated on Oct. 5, 2012http://www.sportline.com/manuals/WV2787BK.pdf

Attached is an image of the instructions. - Jim

There is a little weight that moves up and down every time it is shook (i.e. a step is taken). It uses an average human stride length (some can be adjusted) to calculate the distance.

If the Manufacturer warranties the Product comprising Water Spill Damage, you will get it replaced for free, if this is not, you will have to pay. See your User Manual or contact Authorized Dealer.

First, press the mode button (the one in the middle) until either the alarm set screen or the time screen shows. Second, while in the alarm set or time screen, simultaneously press the split/reset select button and the start/stop set button (the two outer buttons). The alarm symbol should go away (this is normally in the upper right corner of the screen).

Press and hold the RESET button for 6 seconds.

The CR2032

you would use the cr2032

I was looking for instructions for a different model when I found the instructions for the 347 here: http://www.sportline.com/manuals/345.pdf

Cgregor, that was your answer. Try actually being grateful for the help and voting.

It takes a 1154 which is hard to find but there are substitutes available. Here's a link to 1 on EBay. You can also google "battery 1154"

how to settotal fitness pedometer

Ask the Pedometer search engine, they already found a lot of Sportline manuals.

ask the pedometer manual search engine , they can provide the user manual.

Get the manual hereJust ask them for the 220 manual.

The Sportline 4202 has three buttons, Top MODE, Right S/R (RESUME/STOP), Left SET.

MODE - press once to alternate between Steps (how many steps you taken) and Miles (how many miles walked).

S/R - Clears the count to 0 for any mode by pressing one second. To change from Kilometers to Miles or Back Press S/R for 6 seconds.

R/S press one sec and then press SET one second to set "goals" for both steps and miles.

To change length of stride: press the buttons one at a time in the following order- R/S-SET-MODE.

It may take several attempt to get into the set stride and it may take you into other menus such as Goals in the process, just keep going in circles until you get to stride and change length with R/S and set with SET.

ask the pedometer search engine