20 Most Recent
Coleman 10' X 10' Sundome Tent 9160K101 - Page 9 Questions & Answers
I was given an old coleman camp stove
If you go to www.coleman.com/coleman/manuals/ you can get the manual just about any product they ever made. you just need the model number this is usually printed somwhere on the product and will be clearly labled.
The entrance door handle on my coleman natache pop
I also have the same problem. The only way to get into the panel (without completely tearing it apart is to drill out the rivets across the top of the door. The reason the screw is turning is because inside it's held in place with a nut that is turning. You can get to those nuts once the top panel is removed. Can you do me a favor? Where did you find your replacement handle? I've been looking everywhere and it would be SO helpful to be pointed in the right direction!
Need Coleman Generator Service Manual
Hi,
After a Lot of Research and Data Collection, i could ONLY find One Place where you could Buy this Manual. It is not available EVEN for Sale with ALL the Major Vendors.
You could Buy it from :-
http://cgi.ebay.ca/COMPLETE-SMALL-AC-GENERATOR-REPAIR-SERVICE-MANUAL-/250605281081
Let me know,if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
What kind of oil do I usd in my powermate 5000
Use SAE Grade 5W30. Use syntheti or regular oil but do not mix the two. The unit holds about 22.5 ounces so you can drain what is in it and start fresh if you want to switch over to synthetic. Engine wise the synthetic will last longer. Joe
I have a coleman powermate 6250 generator it get
Lets see, Do you have any ether or old school lighter fluid? If you use ether spray a little into the air intake just before you pull the cord for a start, if it starts you have a carb problem. Same for the lighter fluid, remove the spark plug and squirt a small amount down in the cylinder, again if it starts you have a carb, probelm. Take the carb. off the engine take note of the rods and springs, take a picture get it in good focus so you can put it back together. Take the fuel bowl off the bottom of the carb and clean the jets and all see if that will help.
Centre pole is failing to hold tent up in any real wind
TRY DRILLING A SMALL HOLE ON THE INNER POLE SLIGHTLY SMALLER THAN THE DIAMETER OF THE SCREW. U WILL WANT TO DRILL SMALL HOELS EVERY FEW INCHES(CM) SO THAT U WILL BE ABLE TO SET THE POLE AT VARIOUS HEIGHTS IN THE FUTURE.
Not finding what you are looking for?