20 Most Recent
Free Spirit FreeSpirit Model 30727 Treadmill Walking Belt - Page 4 Questions & Answers
Lube Belt Alarm for CT5.4 Not Removed
If you're seeing the "Lube Belt" alarm on your treadmill and the usual reset methods haven't resolved the issue, it's possible that resetting the mainboard could help. Here's a general procedure to reset the mainboard of a treadmill:
1. Turn off the treadmill: Make sure the treadmill is completely turned off and unplugged from the power source.
2. Locate the reset button: Look for a small reset button on the mainboard of the treadmill. It is usually a small hole that requires a pin or a paperclip to press.
3. Press and hold the reset button: Insert a pin or a paperclip into the reset button hole and press and hold the button for about 10-15 seconds. This will reset the mainboard.
4. Release the reset button: After holding the reset button for the specified time, release it.
5. Plug in and turn on the treadmill: Plug the treadmill back into the power source and turn it on. Check if the "Lube Belt" alarm has been cleared.
If the reset procedure doesn't resolve the issue, it's recommended to refer to the user manual or contact the manufacturer's customer support for specific instructions on how to reset the mainboard of your treadmill model. They may be able to provide further guidance or troubleshoot the issue remotely.
Remember to always prioritize safety and follow the manufacturer's instructions when dealing with any treadmill maintenance or repairs. I hope this helps, and I wish you success in resolving the issue with your treadmill!
Calibrate incline on Tjojan tr500 treadmill
Method 1: Press Stop and Speed Up, Insert the Key
To calibrate the incline, press and hold the stop and speed increase buttons. While holding the buttons, insert the safety key. The machine will now be in calibration mode. Press the Stop button once. Then, press one of the incline buttons to begin the calibration. It is recommended that you do not stand on the machine while the calibration is taking place.
The machine will move to its highest incline position, then to its lowest decline position. Please wait for the machine to come to a complete stop. When the machine stops moving, the calibration is complete. Remove the safety key from the console to exit calibration mode.
Method 2: Press the Stop Button, Insert the Key
To calibrate the incline, press and hold the stop button. While holding the button, insert the safety key into the console. The machine will now be in calibration mode. Press the stop button once. Then, press either the incline up or incline down button to begin the calibration. It is recommended that you do not stand on the machine while the calibration is taking place.
The machine will move to its highest incline position, then to its lowest decline position. Please wait for the machine to come to a complete stop. When the machine stops moving, the calibration is complete. Remove the safety key from the console to exit calibration mode.
Not finding what you are looking for?