How to install your Stereo

Please go here:

http://www.usa.canon.com/cusa/support/consumer/printers_multifunction/pixma_mp_series/pixma_mp210#DriversAndSoftware

Then choose Dirvers and Software
Then select OS (Operating system)
A list of drivers and software will appear choose and download.

Good luck!

Hope this helps!

Please rate if this helps!

Regards,

Yes. In most cases you can reset your D-link DP-300 series or DP-301 series print server yourself even if you don't know the password or IP. This comes in handy in situations such as when the server has made up its own password after being connected to a new router.

Cross your fingers and try the following steps...

1) Install the psadmin software if you have not already. If you have lost the psadmin software then search for it on the web.
2) Start the psadmin software and click "factory reset".
3) If the software demands a password, try "SYSxxxx", where xxxx stands for the last four digits of the MAC address located on the underside of your server. (Example: if your MAC address were "63 XE 29 44 F2 96", then your password would be SYSF296.)
4) Click yes to confirm the reset.
5) Follow the non-intuitive instructions provided with your server to set it up again. (Note that a Quick Install Guide will likely be more useful than a manual for this step. If you have lost your Quick Install Guide then try downloading it from D-link's website, http:/www.dlink.com/default.aspx Locate your model via "product quick find" or "find your product" then click on "support resources" and look for a quick installation guide.)

Good luck!
Shahzad IT Department Mitsubishi Motors KSA

Here is the link to see how to setup your motherboard with all the cables in it.

www.760GXK8MB.com

Installing a motherboard seems to be very easy, but there are many tricks involved in the process. If your motherboard isn't correctly installed you will face problems like overheating and system crashes (computer "freezing", "locking", "resetting" – you name it). This tutorial is a step-by-step guide on how to correctly install your motherboard, avoiding such troubles.
Good luck!

First start with pulling out the radio and make sure the antenna wire is plugged in. The last owner might have had an aftermarket radio in it and when they put the factory one back, forgot a wire. To remove it remove the trim ring (two screws I think) and then the radio screws.