Dishlex Global 2000 starts makes a constant noise tries to start up then stops. Bit of water in the bottom of the dishwasher. Lights flash but does nothing

this is an error code and means the wash motor has failed & needs to be replaced.

Hi,

The symptoms on a Dishlex Global 300 dishwasher:

• eco light is flashing constantly;
• noise on pump running continuously;
• but the unit will not operate.

Possible corrective actions include:

• water level - pls check incoming water pressure, filter, water level sensor, water valve;
• base/bottom overflow sensor - there is a float switch in the base of the machine inside a small plastic dish. Behind the kick panel, access through a metal lid/panel/cover secured by 2 small screws. Dry completely the area;
• Air/dry/ventilate the unit/system for a couple of days;
• reduce incoming water pressure.

Hope that this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

Hi just read your posting.Now the reason these dishwashers flash ECO is because there is either water in the bottom tray or your drain pump is open circuit.Is the machine making a pumping noise when it is flashing the ECO light,or is it completely silent?Please reply on additional information and I am sure I can help you.Looking forward to your reply.

ok this sounds like your water has stopped coming in or timed out b4 the pressure switch is activated. hold eco button down, u will hear a beep then a light will come up, keep pushing the button until u see the light.reply and tell me which light has come up, and i can help u fix the problem.

i think it means the water heater in the dishwasher is not working,or the element is shot.
my 300 had a burning smell before the light started flashing.

theres a round plug in the top of dish washer pull it out and clean could be cloged or the bottom spram arm can be pulled out and cleaned aswell

water in the flood switch tilt the dishwasher back then try again

Thomo, make sure the sprayer holes in the spray arms are clean. Grains of rice seem to be a dishwashers biggest enemy as they don't desolve and eventually end up lodged in the spray holes. The holes at the end of the spray arms are the ones responsible for the washing out of the soap powder from the dispenser, if they are blocked this does not happen.
Hope this helps
Cheers

I am hoping I have just fixed mine with same problem. Couple weeks ago started stopping at start of cycle with fast button flashing. Check filters so one on top of unside machine and one on tap if you have one on there. Mine were blocked but still wouldnt work. I pulled out machine to find a kink in the water pipe. I have straightened this out and up to now its working. Fast button flashing refers to water inlet problem.

try holding the start and program buttons simultaneously for a few seconds, it seemed to reset itself for me-i have done this a few times now.