Fisher@paykel aquasmart WL80T65CW1 fault code245 and code49

please visit link below for more information on your error code.




http://www.searspartsdirect.com/washer-repair/error-codes/fisher-paykel-aquasmart-top-load-washer-error-codes.html




Fisher Paykel AquaSmart Top Load Washer Error Codes Sears PartsDirect

250. (11111010) SmartPump Loss Of Sync
This fault is normally as a result of the pump not starting. This fault is usually caused by an
object that has gotten into the pump, and is either under or on top of the impeller, which is
causing the motor to stall when it is trying to start.
Primary Source: Pump Stator Windings Open Circuit.
Action: Measure the resistances of the pump stator. For more information
refer to the AquaSmart service manual.
Secondary Source: Pump System.
Action: Follow procedures as for Fault Code 249.
Tertiary Source: Motor Control Module.
Action: Replace Motor Control Module.

You will need a technician to fix this,

Try to get a Rotor position sensor as they are cheaper.
105. (01101001) Comms Error Time Out
These faults are reported when the Display Module detects an error in the communications
between the Display Module and the Motor Control Module.
Primary Source: Display Module.
Action: Replace Display Module.
Secondary Source: Motor Control Module.
Action: Replace Motor Control Module.
Tertiary Source: Rotor Position Sensor
Action: Replace Rotor position Sensor. If this corrects the fault refit the
original Display Module and/or Motor Control Module.

shouls not make any diffrence but i dont know you original question ?

this model is prone for the suspension rods to weaken and cause fault,fit new set of suspension rods

Yes the shop you bought it from. At only 12 months old the warranty should still apply.

Fault 49 on F&P agitator models is bad cold water valve or wires on it disconnected.

The 1.6 Amp fuse is blown in the motor controller.

maybe it could be the board is not crrectly in place so look at that first