Hello - when I turn on my reebok treadmill, the only buttons that work are start and incline (incline works most of the time). All of the other buttons do not work. Its a Reebok Vista RBTL13305 model...I took off the motor panel and loosened the display board backing ...not sure why though because I don't know what to look for. I paid ~$800 for it about 3 yrs ago...I've used 50-75 and I'd really rather not have someone out here for $200-300...any help is much appreciated. Thanks in advance for your help. Best Regards, Sebastian Jano

If your Reebok Jet 200 treadmill is stuck at an incline and you are unable to lower the incline to the 0 position, there are a few things you can try to fix the problem:

1. Check the incline motor and make sure that it is properly installed and functioning. If the motor is damaged or not functioning properly, it may be causing the incline to remain stuck.
2. Check the incline control board and make sure that it is properly connected to the incline motor and other treadmill components. If the control board is damaged or not functioning properly, it may be causing the incline to remain stuck.
3. Check the incline cable and make sure that it is not frayed or damaged. If the cable is damaged, it may be causing the incline to remain stuck.
4. Check the treadmill's belt and make sure that it is properly aligned and tightened. If the belt is misaligned or loose, it may be causing the incline to remain stuck.
5. Check the treadmill's power supply and make sure that it is properly connected and functioning. If the power supply is not functioning properly, it may be causing the incline to remain stuck.

If you have tried all of these steps and are still having issues with the incline on your Reebok Jet 200 treadmill remaining stuck, you may want to consult a professional for further assistance. A treadmill repair technician will be able to diagnose the problem and recommend the best course of action to fix it.

check and test safety [kill ] switch- circuit - motor

If you wish to get some details about treadmill ; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/

If you wish get some details about treadmill repair check the link below
www.electro-medical.blogspot.com

Check this link for the manual of this treadmill:

Reebok 8400c Treadmill Manual

Treadmill Lights Up But Fan And Belt Wont Run

1) lube the motor elevation, shaft +gear and adjust the POTentiometer a little
2) see the diagram attached,
3) Run the software calibration for troubleshooting,
4)test the relais for open or faulty coil,and clean the contacts very well
God bless you

Hello,

With the motor cover off and the power on, make sure there is a red light/led lit on the controler, if yes then press the start button then press #3 on the speed side. If not lit, you dont have power to the controller. If you had a red light, and pressed the speed button, the light should start flashing just before the walk belt starts to move. If the speed button is pushed and the light on the controller does not flash, you have a problem in the console. This is only fixed by replaceing the controler.

Sorry.

Hope this was at least helpfull, Matt

If you need further help, I’m available over the phone at https://www.6ya.com/expert/matt_8dbc24bf722649ac

No need to take console apart, power up the treadmill, take the safety key out then hold down the start button and the incline down button at the same time then insert the safety key. You'll now be able to toggle between KPH and MPH by using start button

reebok 8000es incline keeps going up and down and will not stop or go into any other mode

my treadmill is doing the same thing. the only buttons that work are the start; incline up. 4 incline; 8 incline; and 11 incline.