My Westinghouse TV TX-42F970Z is dead. Where is the fuse, and what does it look like, please?

Westinghouse tx-42f430s wont turn on fix repair - YouTube

? 5:29
https://www.youtube.com/watch?v=DdfLu5RdVEQ
May 12, 2014 - Uploaded by After Hours Tv & Pc repair
Westinghouse model # 32H1G1 won't turn on , but If I unplug the TV and wait for a ... -tx-42f430s-42-inch-lcd-tv-appears-bricked-595806.html ... I have a Westinghouse 40" TV that is working, but sometimes it won't turn on.

Westinghouse LED LCD TV Repair - YouTube

? 12:32
https://www.youtube.com/watch?v=DGg5iuFEfdM
Feb 8, 2014 - Uploaded by INSIDEHARDWARE CHRIS
Westinghouse Model: LD-4680 Similar (LD4655VX LD4255VX ...Samsung LCD TV Repair - TV Won't Turn On - How to Replace Power Supply ...

40 inch Westinghouse lcd tv black screen help - YouTube

? 1:39
https://www.youtube.com/watch?v=tKLRihGgZAs
Nov 21, 2011 - Uploaded by Jason Flynn

Please contact any service Technician. This fault can't be rectified by you.

Most likely the T-CON board it is dead.The tv have colors vertical lines alway causes by a dead T-CON board,if only this problems,happen by the tv itself only.Not causes by u or an object by hitting it with forces,than the tv LCD screen panel it is damages and tv it is worthless as a whole tv set.Because the tvs LCD screen panels are very important to the tvs and it is 90% of the costes of all tvs.The T-CON board sit in the middle at the bottom of the tv LCD screen panel.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish T-CON board for the replacement.

I would love to assist you in getting your TV back up and running. I need a few more details from you so I can better assist you. Please send me a quick email to [email protected] so I can trouble shoot the problem live with you.

This is known as SLEEP MODE problem.

Simple solutions:
1. Get a power surge protector / strip.
2. Plug your TV power cord to the power surge.
3.Then turn-on your TV using the remote control. Just in case it won't go all the way to normal state.
4. Turn-off the switch of your power surge like 5 times with an interval of 3-5 seconds.
5. Then repeat step 3 and 4.
6. These step is done to over-ride the sleep mode.

Roan

The picture relates with your board. Your need to de-solder the heat sink cover to get access to its fuse. Open it carefully and replace the fuse.

good luck

make sure tv is on correct source for that hdmi input.

Hello, I will need a bit more information to help you out on this one. I can troubleshoot with you live on this one just simply email me your contact information to [email protected] or send me an email and I will give you my contact info.

More likely it's because of power circuit of your TV set. If you are not trained enough in repairing TV sets, appeal to your local repair center