Washer will not start , od code is showing on the panel

This is an open door error. check the latch and switch on the machine.

The "od" code appears when you must open the washer door. The Maytag Neptune washer requires that you open the door between cycles.

Read more: Maytag Neptune Washer Error Codes ' eHow.com http://www.ehow.com/list_7170826_maytag-neptune-washer-error-codes.html#ixzz2GZKry68n

Google this Neptune TL Washer FAV6800AWW

You will find FAV6800A help for solving the OD error code.

See if this post will help http://www.fixya.com/support/t5958665-od_error_message_when_try_start_wash

Yes, OD is a open door error code. You may need a new door latch assembly. pn 22002262.

Hi there,

can you provide the full model # and also the full error message?

Maytag's service center emailed me back saying that I needed to purchase a magnet for the right side of the lid, even after I sent them photos of the lid. There is no magnet on the right side, so don't be fooled! The lid comes apart fairly easily. First, with a screwdriver, apply a little downward pressure and pry out the center liquid/powder holder. It is hinged on the bottom and will come right out. Next, pull out on the bottom corners and the lid liner will come straight down. Now you can verify that the magnet (on the left side!) is there and seated correctly. If that is the case, go ahead and reassemble. Unplug the washer. Lift up the top portion of the washer (at the crease). You may need a screwdriver to pry up on it. I didn't. I just pulled up on it. It comes up fairly easily. Now you can see the locks, mounted with one bolt on either side. Inspect the wiring for any wear or damage. Next, remove the locks one at a time, unhook the wire connector and plug them back in. Reassemble. Leave the lid up (not sure if it matters, but I did) and plug the washer back in. That's all I did and it worked! The "od" alarm didn't come back.

Could od mean overload? Reduce or actually weigh load and re-try