I have i polaroid procam its old i just found it and it takes the picture but then it doesnt come out, can this be fixed?

I THINK A PICTURE IS STUCK OR GLUE HAS IT STUCK OR BATTERY IS LOW OR DEAD, THUS NOT ADVANCING THE FILM.

Ok so I have the same problem I went out and purchased an SD card...but it doesnt work. So I called Polaroid and you need to purchase a CLASS 6 SD card of 2gb or more for it to work properly...figures it does not say that in the manual.

You can download a manual here:

http://www.retrevo.com/support/Polaroid-TTM-2003-TVs-manual/id/279ag000/t/2/

Take a flash light and point it close to the screen . do you see a picture.

You have a bad back light or inverter the powers the back light. in any rate here the unit will need a repair shop because these are hard to get to you have to dig.

let me know ether way/


thanks for asking your questions please do rate and leave feedback.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/edwy_1a56970cf1ea4620

How old is the film in it?

Polaroid film packs have a battery included (a polarpulse powercell, I think).

If its an old film, the battery can go flat and as far as I'm aware there's no way to get power in to it.

I would take the cartridge out, (effectively not use the last shot), try a new cartridge to see if its working properly, then send the old cartridge back to Polaroid, if you think its faulty.

How old is the film in camera & when did you put in the film?

Polaroid's battery is built in with the film package.
If the package is old or been in the camera for a long time battery may be low or dead.

Try changing film out.

Good Luck! Hope this helped. Please rate.
MSG back if you need more help.

I typed in Polaroid ProCam into google and the first result that popped up is a manual:
http://www.polaroid.com/service/userguides/photographic/procam_ug.pdf

Instructions on changing the date is on page 15.
Hope this helps : )

The grainy effect has to do do with the ISO setting, try adjusting that. A higher ISO is generally better for darker conditions. I have noticed that this camera frequently takes grainy images.

Hey guys, I read the solution about replacing the 10v 1000muf caps in the power supply module. I was ready to throw the set out. I tore apart an old old old Jerrold 700 converter and found a couple of caps that were 1000muf. One was 26v and the other was 52v. Anyway, the set works great now and I now have a 37" LCD in my shop to watch the Leafs!!!!
Thanks for the advice.
StereoSteve.

I had the same problem. But found the fix on this website!!

http://www.fixya.com/support/r741402-polaroid_flm_373b_lcd_tv_black_screen