Check this out.
F25
Desired temperature fault
At the end of the wash program, the display shows the message
Technical fault code F25 - Call Service Dept. The Status LED flashes. The buzzer is activated for 2 minutes. During the heating stage, the desired temperature has not been reached within the given time (minimum 75 minutes). In subsequent wash blocks, after this fault has registered, the heating is not activated and no rinse aid is dispensed.
Cause:Heater defective.
Remedy:Replace the heater.
Cause:Heater relay defective.
Remedy:1. Check the heater relay solenoid.
2. Check the heater relay solenoid voltage (12VDC) from the electronic.
3. Replace the electronic, if necessary.
Cause:Excess quantity of detergent or rinse aid dispensed. Excess foam has developed.
Remedy:Check the dispensed quantities of detergent and rinse aid. Follow the information given in the operating instructions
F25
Desired temperature fault
At the end of the wash program, the display shows the message
Technical fault code F25 - Call Service Dept. The Status LED flashes. The buzzer is activated for 2 minutes. During the heating stage, the desired temperature has not been reached within the given time (minimum 75 minutes). In subsequent wash blocks, after this fault has registered, the heating is not activated and no rinse aid is dispensed.
Cause:Heater defective.
Remedy:Replace the heater.
Cause:Heater relay defective.
Remedy:1. Check the heater relay solenoid.
2. Check the heater relay solenoid voltage (12VDC) from the electronic.
3. Replace the electronic, if necessary.
Cause:Excess quantity of detergent or rinse aid dispensed. Excess foam has developed.
Remedy:Check the dispensed quantities of detergent and rinse aid. Follow the information given in the operating instructions
Hello there and welcome to fixya
Can you please provide me with the exact f-code you are experiencing so i can get you the right information you will need to troubleshoot this problem
The washer will complete app. 80% of the cycle and then stop and give the error message, F6. For some reason, it will not complete the final spin cycle.
hello there again sorry you could not find any error code for this here is some info that may help youIf the washer stops mid-cycle the main control board might be defective. This is not common. Check other causes first such as the lid or door switch and other components .If the washer stops mid cycle the timer might be defective. This part is often misdiagnosed, check other components before replacing this timer. i would first test out the timer this isthe most common issue with this machine ok please get back to me if you are able totest and i will give you the instructions on how to do this ok? best regards Mike
×