Dl error will not clear - Whirlpool Cabrio WTW6600SBT Top Load Washer

The DL error code is an indication that the door lock is having problems locking the door or confirming that the door is in fact locked. This is usually caused by a defective door lock assembly, wiring connection problem or the machine control board.Mar 9, 2009

Why is my Kenmore washer displaying a DL error code?

and more

https://www.google.com/search?q=Kenmore+top+loader+DL+error+code

..

The DL is a door lock error but it can also mean an error with communication to the main control board o

First try to unplug all your connections to the main control board and plug them back in and try it again.
Sometimes a wire harness just may be loose.
If that does not work.
You need to replace main control board .


SAM ANDERSON

If you wish to get some details about refrigerator repair then check the following link ; visit the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

Hello,

I advice you power off the magicolor 2430 DL and power on after few minutes, while the magicolor 2430 DL is loading or booting, pull out the plug from the AC outlet and wait for minutes before plugging it back and power on, if the problem still per, press the stop button for about 5 seconds and release, see what happens, if it fix the problem.

Let me no what happens.

Take care.

"Fdl" is a door latch error code. This is an indication of either a defective door latch, defective Central Control Unit (CCU), or an interconnecting cable problem between the two. The following link explains how to troubleshoot the problem:

http://www.fixya.com/support/r4490349-fdl_error_code

I have included parts resources, if required, and the steps required to replace any defective parts.

If you have any questions, please post back and let me know. I hope this helps you.

error 0094h = 2nd image transfer pressure/retraction failure
basically it means that either a sensor or cable is not fitted supposedly and reseating could possibly solve the issue.

you can research the error code in the following service manual:
http://printer.konicaminolta.com/drivers/other/Manuals/5400/smfs_54.pdf

If you already replaced the latch, and still get fdl, then the problem is wiring harness to timer board or timer board connections, check them out.

The door may not have been fully closed. stop/clear cancel the cycle. ensure door is fully closed and attempt to resart cycle.

F/dL Door Lock Error
A Door Lock Error occurs if the door cannot be unlocked. It will try to lock it 6 times before displaying the error.

• Door Lock Mechanism broken or removed from the Door
• Check Door Lock/Switch Assembly
• Check the wire harness connections to the Door Lock/Switch Assembly and Central Control Unit (CCU)
• Door Lock/Switch Assembly Failure

check your wireharness from door lock assembly to the central control unit,,wire broke

had printer for approximately 2 years. Used daily in office setting. today the printer tried to print, then just stopped and it said fatal error 17H in the window. We cleared paper jam and rebooted, gives the same error message. Anything we can do?