Door on my frigidaire affinity wont stay close

https://www.searspartsdirect.com/diy/symptom/dryer-repair/1234594/door-won-t-stay-shut/dryel07

you may have broken off a piece of the latch
(hook portion) either on the door or the receiver portion on the machine. check for diagrams online using model #

I’m happy to assist further over the phone at https://www.6ya.com/expert/howard_977676954994c5b2

Good Afternoon Mr. T,

I understand that you are having trouble with your Frigidaire Affinity dryer and the door sagging, making it difficult to close and latch the door. I suggest contacting your local authorized technician for assistance with this. They should be able to realign the door without any complications. Hope this is helpful.

-Best Regards-
WP

Hello zabbster - Typically the DR or DO error code indicates that the door switch is not closed. Make sure that the door lock is completely closed. If the door is closed, make sure the door latch is not broken. If the latch is broken, you may possibly need to replace the door lock switch.

You will need to replace the door catches on the unit

your door clip needs to be replaced or realign
your door

Yes, the original issue was the control from the beginning. the control is damaged and it cannot register the latch at this point. this is necessary and , it will fix the issue.

in the rubber seal around door to washer tub ensure there is nothing inbetween rubber.

Try holding the 'options' & 'select' buttons together till the door lock button comes on. This is the child lock function. You can do it again for the lock to come off. Hold down for over 3 seconds

Please reply or rate.

If the washer fills with water, but will not start the wash cycle or spin, it is 1 of to things. the most common for frigidaire front load affinitys is the door lock assembly. I have had to replace numerous of these. if the door lock indicator is not on when it tries to wash, you need to replace the door lock assembly. if the door lock indicator is on, but wont wash, it is likly that you have a bad motor control board.