Where do i find discontinued jenn air cooktop parts. My fan switch went out and needs replacing

I have a Radio Shack 3-in-one remote control 15-302 and I need codes for Dinex TV..it says it is 4 numbers

It appears you simply have a bad switch. Try contacting Jenn-Air or looking them up on the web to find out if they have replacement parts available

hELLO THERE
This part
looks like this picture below right if so it has to be ordered thru the manufacture
Fan Switch

Item # 1953
Down draft fan switch, gray

This part may have been permanently discontinued by the manufacturer and we don't know of any source for the part except the manufacture or there supplier
Skill Level

N

I have two of the 71001494 fan switches new.

Hi,

Here is the part number for the switch 74009254

Just fixed this problem and repaired the corner of the Ceran cooktop.

Disclaimer: These cooktops run on 220V and will kill you if you don't know how to work with electricity. If you're unsure, get some help.

The boiling water slopped out of your pot, and went over to your controls (knobs) and went down the shaft and into a component call "Infinity Switch". The water caused the switch internally to weld one of the two internal sets of contact points into a permanent position. The fix is to replace the
"Infinity Switch" that the boiling water spilled into. The Infinity switch is the component that the control knob slides on to.

In my cooktop one of the infinity switches failed and appears to damage the adjacent switch. Mine actually caught on fire and damaged the wiring and the connector. Hopefully you are better off. Since they were in such close proximity I replaced them both. For $20 you might consider the same. I replaced both to be safe and they were $21.47 each.

My cooktop has 4 elements 2 small, 1 large and 1 combined (small and large) surface. A large element was definitely damaged and possibly a small element. I ordered both. I mention this in case a multi-element was damaged on your cooktop.

You will need to contact either Jenn-Air or someone. Since you can't see an exploded parts list online, you'll have to use the schematic. It is in a plastic sleeve and it stuck to the side of the ventilator housing underneath the cooktop.

When you wire the new part in, make sure you have the wiring correct or when you turn it back on you will burn up the new part.

I hope this helps.

the unit doesnt have any internal fuses. you have a house fuse blown or circuit breaker that tripped. the fan switch can be found online or from your local parts house and make sure you get the clips to hold it to the mounting tabs.
next time you get ready to work on it, just make sure and turn off the power first as you will touch the metal terminals to the frame again.

you can find the parts breakdown at sears.com parts
I looked up the fan switch # for you it is Part # 74009254
it is a big job to replace just remember to turn of breaker.

1. Turn off the power at the breaker box.
2. lift off the air grill.
3. remove the two screws at the front of the control switch panel (escutcheon)..
4. slide the control panel forward until it disengages, then lift up to expose the switch assembly and wiring.

short in the fan wirring.. it is not easiy fix . you need to replace the fan and short wieeing.