Replaced Mobo & Processor Nothing Working

If you "popped" the power supply, I would check to see if the RAM might have taken a hit as well. Ram chips and CPU are sensitive when it comes to power surges. I would troubleshoot the system, unplug everything. you need monitor, power, cpu, and ram (1 at a time). Check to see if the system will POST. if you do get it to POST, start with 1 item at a time and see if the system will POST every time. If nothing happens, there is a chance you may have a damaged motherboard or cpu.

You need to disassemble your motherboard specially the processor and the RAM. Once the RAM and the processor was removed you need to clean the motherboard. Re assemble the unit, put thermal paste to the processor so that the heat will absorbed by the heatsink.

hi there..

i also have the same mobo like yours. i also thinking to upgrade my old processor with better one..

made some quick research.. i would say the mobo unable to support the new processor. checked the BIOS update n CPU support list in Abit's site..

didn't show X4 processor is supported :(

1.*********** Board not supporting Your Processor.
2. Try With Lower Speed Processor
3. Mahe sure that Mother Board is Working or Faulty.
4.Check the ram twice

If it HELPS RATE ME!

Usually this symptom has to do or with memory modules with problems or the VGA adapter (integrated) could be damaged. First try to reset the BIOS of *********** taking out the battery and using the reset jumpers informed in the Mother Board manual. Then put the battery and the jumpers back to the factory default position and try again.
If this doesn't work, try to plug the power cord to another 220V as the ground could cause this type of problems.
You can also try to install another VGA adapter to check if you receive the VGA signal in your monitor.
Hope it helps...
Please tell us about your progress.
Best regards
Eduardo

First step is to check and make sure that all cables are connected properly and that the RAM is seated properly. Also are you using onboard video or an add on card?

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/larry_1fe25e09c54eece2

You need to have a PSU greater than 450watts. that could be the problem..

Could be the power supply is not strong enough to power the system. Replace the power supply with one that is between 350 - 450 watts. This should provide ample power to the system.

I SEE YOU MENTIONED NOTHING ABOUT INSTALLING ANY DRIVERS FOR THE HD'S DID YOU?
GOOD DAY
KZ

have you tried to reset the cmos