PRINTER JAM MY PRINTER HERE AT WORK JAMMED. I HAVE ALREADY REMOVED THE JAMMED PAPER IN THE FRONT LOADER AND IN THE BACK BUT THE PAPER JAM IS STILL ON AND IT PRINT. HELP... I HAVE SEVERAL REPORTS TO PRINT BEFORE THE END OF MY SHIFT. THANKS.

Hi......................
How to Clear a Paper Jam on an HP Inkjet Printer?????
Paper jams are among the most common problem with HP inkjet printers. Follow these instructions to learn how to clear a paper jam so you can get back to work.

Instructions Things You'll Need

• HP inkjet printer

1. • 1 Disconnect the power cord from the back of the printer before you begin. With the power disconnected, you will protect yourself from being shocked. This is an important step when you are fixing any type of electronic device.
     
   • 2 Move your printer so that you'll have access the back panel. Unhinge the back access panel of the printer.
     
   • 3 Look for paper through the opened back panel. Remove any paper you find jammed.
     
   • 4 Close the back access panel. Make sure that it latches into place and looks the same way it did before you opened it.
     
   • 5 Open the front or top access panel. This is the panel you use to access ink cartridges. If the carriage that holds the ink cartridges moves, then you forgot to unplug the printer. Go back and do that now. Look for paper that may be jammed in this area of the printer.
     
   • 6 Remove any paper you find jammed here. There will be resistance from the paper feeder, so pull slowly or the paper will rip and create a more serious problem.
     
   • 7 Close the front access panel. Make sure that it latches back into place.
     
   • 8 Plug the printer in and attempt to print again. If you can print successfully, you have removed the paper jam.
     

Hope this will helpful to you...................
Good Luck.............

Hi,
Welcome to FixYa.
Paper may get stuck or jammed in the printer. Follow instruction below to find and remove jammed paper.
1. Turn off the printer.
2. Unplugged the cable of printer from the computer.
3. Remove all loose paper from the paper tray.
4. Do not pull jammed paper from under the front cover.
5. Press the resume button, If the paper is still jammed maybe there is still some scrap of paper, proceed to the next step.
6. Remove the back door or rear access door.
7. Pull the jammed paper out of the printer.
8. Check to make sure no scraps of paper are stuck in the printer.
9. Put the rear access door back into the printer.
10. Plug the cable printer to the computer.
11. Turn on the printer.
Hope this information will help.
Thank for using FixYa.

Clear the jammed paper as follows.

If the jammed paper is removed completely by using the information in the following steps, you can install the paper tray first, and then close the front cover and the printer will resume printing automatically.



If the printer does not start printing automatically, press the Go button. If the printer still does not start printing, please check that all the remaining jammed paper has been removed from the printer. Then try printing again.

Pull the paper tray completely out of the printer.

Pull the jammed paper up and out of the printer.

Press the cover release button and then open the front cover.

Pull out the drum unit assembly. Pull the jammed paper up and out of the printer. If you cannot remove the drum unit assembly easily at this time, do not use extra force. Instead, pull the edge of the jammed paper from the paper tray. If the jammed paper can not be pulled out easily, turn the jam dial towards you as you gently pull the paper out.

Open the face-up output tray. Pull the jammed paper out of the fuser unit. If the paper jam can be cleared, go to Step 7.

Open the jam clear cover. Pull the jammed paper out of the fuser unit.

Close the jam clear cover. Close the face-up output tray. If the paper jam still cannot be cleared, for HL-5130 and HL-5140 users go to Step 10, and for all other users go to the next step.

Pull the Duplex Tray completly out of the printer.

Pull the jammed paper out of the printer or the Duplex tray. Put the Duplex tray back into the printer.

Push the lock lever down and take the toner cartridge out of the drum unit assembly. Take out the jammed paper if there is any inside the drum unit.
Put the toner cartridge into the drum unit until you hear it lock into place. If you put it in properly, the lock lever will lift automatically.

Put the drum unit assembly back in the printer.

Put the paper tray in the printer.

Close the front cover.

Is the correct model number: HP Deskjet D1320 Printer ? Was printer working properly at one point? May be resulting from failure to fully clear a paper jam:

Paper jam

To clear a paper jam

1. Remove the paper from the paper tray.

2. If you are printing labels, verify that a label did not become detached from the label sheet while passing through the printer.

3. Turn off the printer.

4. Remove the rear access door. Press the handle to the right, and then pull out the door.

5. Remove the paper jam from the back of the printer, and then replace the rear access door securely.

6. If the paper jam cannot be removed from the back of the printer, raise the printer cover, remove the paper jam from the front of the printer, and then lower the cover.

Caution Remove the paper jam carefully as it is possible to damage the printer when removing paper from the front.

7. Reload paper in the paper tray.

8. Turn on the printer.

9. Reprint the document

if this does not help I would suggest installing a new driver from: http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?lc=en&dlc=en&cc=ca&docname=c00211293&product=1839853&

Trust this is helpful. :)

E3 is paper jammed error code. Either paper jammed inside or your Drive Assy is not functioning properly.

Turn of the printer, and do not close any of the tray or doors before all of the jams are cleared.
1). remove the paper from paper tray, removed the tray and remove the jams.
2).open the front cover and removed the toner cartidge assembly, remove any jams in this area, and behid the toner cartridge asembly.
3).left the flap at the front of the printer adn remove any jams heneath the lap.
4).Open the rear exit and remove any james.
close all covers and reinsert the paper tray and turn on the printer.

 Follow these steps to remove a paper jam: 
1. Press the Resume button. 
  If the paper jam does not clear, then go to the next step. 
2. Turn off the printer. 
3. Remove the rear access door. Press the handle to the right, and then pull out the door. 

4. Remove any paper that is inside the printer by pulling it out from the back of the printer. 
  If you are printing labels, verify that a label did not become detached from the label sheet while passing through the printer. 
5. Replace the rear access door securely. 
6. If the paper jam cannot be removed from the back of the printer, raise the printer cover, remove the paper jam from the front of the printer, and then lower the cover. Caution Remove the paper jam carefully as it is possible to damage the 
  printer when removing paper from the front. 
7. Turn on the printer, and then press the Resume button. 
8. Reprint the document. Note If paper jams occur frequently, try using a heavier paper. See the reference guide for paper weight specifications. 

Clearing paper jams
Paper jams can be real or false. The unit may report a paper jam even when there is no jammed paper. The solution to a real paper jam or a false paper jam is the same.
CAUTION:
Jammed paper must be removed using the rear access door with the power cord disconnected to avoid mechanical damage. Do not remove jammed paper from the front of the unit.

1. Turn off the HP product and turn it around so the back of the unit faces you.
2. Disconnect the power cord from the back of the all-in-one. The power cord must be disconnected to allow the paper feed rollers to turn freely.
3. Locate and open the rear access door by pressing in on the left side tab and then pulling the door toward you.

Figure 2: Removing the rear access door

1. Inspect the pressure rollers on the rear access door and verify that they are clean and turn freely. Clean the rollers if needed with a soft towel lightly moistened with water. If the rollers do not turn freely, replace the rear access door. Click How to Buy on this page to order replacement parts.
2. From the rear access door opening, remove the jammed paper.
3. Remove the remaining paper from the paper supply tray. Discard any paper that is damaged or crumpled and then re-stack and reload the paper into the paper supply tray.
4. Reinstall the rear access door.
5. Reconnect the power cord to the unit and turn the unit on.

Preventing paper jams
The following information will help prevent paper jams from occurring:

• Never use paper that is torn or wrinkled.
• If you are having problems using paper that has already been printed on once (recycling), replace it with new paper.
• Remove and then reinstall the rear access door. Verify that the access door is fully locked in place. The paper can skew if the rear access door is not locked.
• Every six months to one year, clean the paper feed rollers with a rag lightly moistened with water. Over time the paper feed rollers accumulate dust and do not function as well as they once did.
• When printing envelopes, tuck the flap into the envelope and crease the folds before printing.

u need to remove the fuser and remove the paper in it, put fuser back in the reverse