Replace the console on a Fisher & Paykel GWL11

See Service Manual for help
Fisher & Paykel DW820 Parts list - download free (nodevice.com)

this is a faulty transducer which is located on the main board unfortunatley you will need to replace the whole thing

Refer this parts diagram.

http://spares.bigwarehouse.com.au/images/files/18196_71ac2010b1b67e91c23c267b28e0cae7.pdf
You have to remove the screws holding the front panel and access the door handle to replace it. Make sure the mains power chord is taken out from the plug.

remove top panel, 2 screws behind console. unscrew, unclip water solenoid assembly, replace, test.

Check the out of balance switch (under the larger Grey board)
for corrosion on the terminals and replace if faulty.

Hi - with aquasmarts there is a plastic dome like fitting in the middle of the agitator & unscrew this to remove the unit.

take the two rubber pieces out of the corner of the top

Hi there you need to replace the motor controller under the touch panel, remove the 2 screws on back of touch panel and pull touch panel forward, the motor controller is the big one on the bottom, remove it and replace, you cant get the wiring wrong they are made only to go into 1 hole,

Hi Dale..
It sounds like you have a leaky inlet valve assembly. The part number is 421029P and is easy to replace. You can get one here:
http://www.fisherpaykelparts.net/ecart/item.php?item_id=266&category_id=56

I have a Fisher & Paykel GW609AU Smartdrive Excellence 6.5 Washing Machine that would start then stop then start then stop a few more times before eventually beeping.
I fixed it by bypassing(joined the white and yellow wire) the trip out switch which is located under the control module(one screw to remove).Now it Works.