Maytag performa dryer pye/g2200

You mean it stay only "Hot" only on any position?
-If so then the switch is defect (Burn or melt inside)
It might need new switch.

Good luck

Mai

Hi,

If your dryer is not drying like it once did or if you just have nottaken the time to give yourself a clean dryer in a long time then youneed to do that. At least once a year the dryer cleaning should takeplace. Lint build up in the dryer duct is one of the main causesfor your dryer to fail.

Here is the rest of this tip about DryerMaintenance

heatman101

Most of the time the dryer blower wheel part number 53-0106 gets loose and and cause this problem. I fixed one just the other day.



If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

check to vent or remove the vent and see if it will work...if the vent is plugged it will take a long time to dry and sensor dry will not work...

Based on the information provided, it sounds like a broken drum belt is at fault. Below is an illustration of the drum belt.
http://www.repairclinic.com/SSPartDetail.aspx?s=t-PYG2200+-%3d%3di529597&PartID=529597

Here is a parts/disassembly diagram:
http://www.repairclinic.com/Dryer-Gas-Maytag-Style-Appliance-Diagram

Here is a belt installation diagram:
Dryers have a drive belt that turns the clothes drum. If the belt breaks, the drum stops rotating. Then you need to replace the belt, and often the idler pulley, because the pulley tends to wear out at the same time.

Click here for a belt installation diagram.

All links courtesy of www.repairclinic.com

if the unit heats and turns the problem you have is in the duct , kink behind the unit or a clog of lint in the duct on its way outside.
Phil

Could be 2 things... either your heat source is out of repair or your vent is blocked. Since you say it only gets warm I'll assume the problem is with the gas coils inside the unit. These parts are replaceable

clean your dryer vent going from the back of the dryer to outside also run a lint brush down where you put the lint screen in if this does not help replace your coils

how long is dryer vent run ? does it go up or out to the side ? Sounds like the dryer vent is clogged. A long run on your vent will also cause this problem with a small amount of lint. Try cleaning out your lint screen on the dryer vent they can get pretty caked up with lint. If you have a long dryer vent run post back the length and direction and I will get you the maximum length for your specific run. You may need a booster fan if it is excessively long or straight up as through the roof.

Do not buy or use a maytag performa dryer model number pye2300ay at all. I fyou have one unplug it and take to the landfill or scrap yard. They are complete junk and nothing but a hassle. One problem after the other on this model no matter what you do. they are complete trash and a waste of your money.