Problem with PPT 8800 Portable Terminal - Symbol PPT 8800 Portable Terminal

If it is not the sound settings then it is most likely a faulty speaker.
Contact www.portablesolutions.com for a repair.

There is a part on the battery cover that activates a switch on the main pcb.
This switch is on the opposite side of the "reset" switch on the back of the machine, near the bottom.
If this switch is not being activated, the machine will not turn on.

Try squeezing the bottom the machine, thereby pressing the battery into the machine harder. Then try turning it on.

Hello, You will get the reference guide for your Symbol PPT 8800 scanner in the following link. http://support.symbol.com/support/search.do?cmd=displayKC&docType=kc&externalId=5809304apdf&sliceId=&dialogID=108884644&stateId=1%200%20108882281 Hope it helps, Good luck! ~regards, Jegan

It will need a new screen. This is a common fault on this type of terminal and since the touch pannel is incorporater on the screen assembly, that is the only solution.

You could always try a software update from IPL mode, however is not very likely that it will resolve the calibration issue.

I can help you ...

Are you referring to the base kit for manufacturing floors ? What is the model number of your base?

I suspect when you say base you are actually referring to an access point. It would likely be model 5131 or (older)4131.

That access point can support many devices. Hence you need only one. Be careful to turn on WEP encryption (or TKIP) on the access point so you don't become the next TJmax!

Hope it helps.

Ok sometimes PABX systems just don't seem to play well with modems... as a thought put a couple of Commas, a "Pause" B4, AND AFTER ya try to dial the 9, IE: ,,9, As sometime it takes a while for the PABX to "Latch on" to the DTMF tones. Thats all I can think of really.

Did it used to work ... but now has failed?