Ty-la1000 has been replaced, but won't light? could it be ballest board.

sound like your lamp is bad ...Panasonic TY-LA1000 Lamp Replacement...Ballast Repair Kit for Panasonic PT-50LC13 some time the ballast go bad as well to hear bouth part number one lamp and 2 ballast I hope this help you..

HI,

Panasonic PT50LC13 lamp indicator blinks to tell you the lamp is faulty.

You need to replace the bulb or TY-LA1000 lamp assembly. This link displays all Panasonic TV Lamps and TV Bulbs. This page shows Panasonic lamp location and How to Replace TYLA1000 bulb. TY-LA1000 Bulb Replacement requires the use of a long Philips Screwdriver to reach screws within the lamp cage.

Unplug AC power before removing the lamp and re-install all doors, etc, correctly before starting the TV. Vacuum any visible dust or lint from air vents and lamp area. Do not used forced air to blow out dust, big problems may result.

The user's manual has a description of what the Blinking LED indicators mean.


Image of TYLA1000 lamp.


Robert

You must remove the plastic cover from the front and just left of center there is a panel covering the lamp with a single screw. Under that the lamp is also held in with a single screw. Pull on the handle firmly to remove lamp. Replace with TY-LA1000 bulb.

Hi,
Turn On tv.
Press and hold Volume Down button on TV Front and PIP/ SPLIT button on Remote at same time for 6 Seconds to reset Lamp Timer and tv will show you timer reset message screen.
Hope this info will help you.
Thanks.

If your tv is around 2-4 yrs or used 6000-8000 hrs,never replaced the lamp before it could be time to replace it.The other most common failure is the board that powers the lamp,which is called the ballast.When its bad it will make a clicking sound or like wanting to turn on.The part # for your lamp is TYLA1000 you can find it here:http://www.discount-merchant.com/Panasonic-TY-LA1000-Lamp-DLP-TV-bare-lamp-p/panasonic-ty-la1000-lamp.htm Good luck and God bless you!

LAMP TY-LA1500 orTY-LA1000 Call Fox they have them for 139.00 1-800-227-5369

Model PT-50LC13?
Replace the lamp .
There is instructions in the owners manual.
Panasonic P/N : TY-LA1000 $150.00

I did a 2nd replacement with an original Panasonic TY-LA1000 Lamp, now my TV works just llike new.

You need to have your Panasonic remote.
1. Make sure the power cord is plugged into a properly grounded outlet and turn on the set with the power button on the projection unit or the remote control.

2. While holding down the (VOL -) key on the projection unit press the PIP or SPLIT key at the same time. Hold it for longer than 5 Seconds. The PIP or SPLIT key is model specific:

PIP for Models:
PT-50LC13/PT-60LC13/PT-50LCX63/
PT-60LCX63/PT-43LCX64/
PT-50LCX64/PT-60LCX64

SPLIT for Models:
PT-43LC14/PT-50LC14/PT-60LC14



3. When the unit resets the lamp timer it will display a screen on the TV indicating it was reset to zero. You press recall on the remote to exit.


You will find a PDF of the instructions at this site:
http://fixyourdlp.com/blog/wp-content/uploads/2007/09/panasonic-tyla1000-lamp-instructions.pdf

not really, just be careful about getting finger prints on the lamp as the oils from your fingers will shorten the lifespan of the lamp.