Question about Whirlpool GD2SHGX Refrigerator
You said, Both Freezer and Fridge compartments stopped keeping optimum temperature. Freezer compartment is working as a fridge, and fridge also not keeping the temperature as it should. Both temperature controls are on maximum (I actually tried many different combination's with no luck).
What is the model #.
How old is it?
If the fridge is only a couple of years old , try turning it off and then! unpluging it for 5 minute and then
if nothing good then most likely it is this next task!
It should be on a sticker inside the door jam or close to it on the inside wall of the fridge.
If it is real small like a counter high fridge, the number may be on the rear.
If the fridge is full size fridge check in the rear to locate where the condenser is. (lt looks like a thin row of black tubes that the freon travels through).
If not and they are under the fridge behind a removable plastic grille in the front of the fridge.
If this is the case then remove the plastic grille to see if the rows of thin (black tubes) called a condenser is covered with one to two inches of dust and not visable yet due to the blanket of dust!
This makes the condenser (black tubes) hot and unable to cool.
Air is sucked in from the front and passes over these tubes and cools the freon.
That is making it hot and the fridge and freezer warm.
You will need a flash light,
The plastic grille comes off when you press down on the top and up on the bottom together. Like squeezing the grille with your fingers until it comes off in your hands.
Get a flashlight, and get down on the floor and look under the fridge at the condenser. If all you see is an inch or two deep of lint and dust, then you need to buy a refrigerator brush at the hardware store and clean the thick coating of dust off.The brush is one inch wide and round with a very long handle 36 inches. Do this very slowly and gently. Remember the freon is in these tubes so you don't want to bend them and get a leak.
I know this was a long explanation but if this is the case I just saved you a service call.
It will take some hours to get cool again if this did not cause any damage to the compressor!
Some times all night till it reaches the max. temperature.
If there is no condenser below, or this does not do the trick, you may need to replace the thermostat!
or have a low freon level.
Waiting for your response
Let me know!
Please remember to leave a rating at the end!
Posted on Oct 22, 2008
Temperature is not working either in the fidge or freezer please can you inform what gas is used?
Posted on Oct 23, 2008
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Feb 23, 2017 | Whirpool Refrigerators
Nov 12, 2016 | Whirpool Refrigerators
Sep 19, 2014 | Whirlpool GX2FHDXVY Gold Stainless Steel...
Dec 29, 2009 | Refrigerators
Feb 22, 2009 | Whirlpool GB2SHDXP Bottom Freezer...
Nov 09, 2008 | Westinghouse Refrigerators
Oct 06, 2008 | Whirlpool GS6NBEXR Side by Side...
Sep 20, 2008 | Whirlpool GS6NBEXR Side by Side...
Apr 13, 2008 | Zanussi Refrigerators
183 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: